- 您現在的位置：買賣IC網 > PDF目錄383986 > USB97C202-MN-02 (STANDARD MICROSYSTEMS CORP) ATA/ATAPI CONTROLLER PDF資料下載
參數資料
| 型號： | USB97C202-MN-02 |
| 廠商： | STANDARD MICROSYSTEMS CORP |
| 元件分類： | 總線控制器 |
| 英文描述： | ATA/ATAPI CONTROLLER |
| 中文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP100 |
| 封裝： | 12 X 12 MM, 1.40 MM HEIGHT, STQFP-100 |
| 文件頁數： | 30/59頁 |
| 文件大?。?/td> | 385K |
| 代理商： | USB97C202-MN-02 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
SMSC DS – USB97C201
Page 30
Rev. 03/25/2002
PRELIMINARY
Table 26 - USB Bus Status Register
USB_STAT
(0xAB - RESET=0x00)
NAME
Reserved
EP2_ERR
USB BUS STATUS REGISTER
DESCRIPTION
This bit always reads “0”.
1 = Indicates that a token in the opposite direction inferred
by the DIR bit of EP2_CTL register was received, ie an
unexpected IN or OUT token.
1 = Host is high speed capable. This bit is set if high speed
signaling is received from the host.
1 = Indicates that RESUME signaling has been detected.
This is only valid if the USB97C201 is in the SUSPEND
state via bit 0 of the SIE_CONF register.
1 = Indicates that a USB Reset has been detected.
1 = Indicates that a USB Error has been detected. See the
USB_ERR register for details. This bit is cleared by clearing
the USB_ERR register.
This bit always reads “0”.
This bit always reads “0”.
BIT
[7]
6
R/W
R
R/W
5
2.0
R/W
4
USB_RESUME
R/W
3
2
USB_RESET
ERROR
R/W
R
1
0
Reserved
Reserved
R
R
The bits in this register (except bit 2) are cleared by writing a ‘1’ to the corresponding bit. These bits are ORed, if
unMASKED in the USB_MSK register, and drive a latch for the USB_STAT bit in the ISR_0 register.
Table 27 – USB Bus Status Mask Register
USB_MSK
(0xAC - RESET=0xFF)
NAME
Reserved
EP2_ERR
USB BUS STATUS MASK REGISTER
DESCRIPTION
This bit always reads “1”.
1 = Prevents generation of the USB_STAT bit in the ISR_0
register when the EP2_ERR bit is set in the USB_STAT
register.
1 = Prevents generation of the USB_STAT bit in the ISR_0
register when the 2.0 bit is set in the USB_STAT register.
1 = Prevents generation of the USB_STAT bit in the ISR_0
register when the USB_RESUME bit is set in the
USB_STAT register.
1 = Prevents generation of the USB_STAT bit in the ISR_0
register when the USB_RESET bit is set in the USB_STAT
register.
1 = Prevents generation of the USB_STAT bit in the ISR_0
register when the ERROR bit is set in the USB_STAT
register.
This bit always reads “1”.
This bit always reads “1”.
BIT
[7]
6
R/W
R
R/W
5
2.0
R/W
4
USB_RESUME
R/W
3
USB_RESET
R/W
2
ERROR
R/W
1
0
Reserved
Reserved
R
R
Note1:
The mask bits do not prevent the status in the USB_STAT register from being set, only from setting the
USB_STAT bit in the ISR_0 register.
相關PDF資料 |
PDF描述 |
|---|---|
| USB97C223 | capacitor Selection for Internal Regulator Output Pins |
| USB97C243 | capacitor Selection for Internal Regulator Output Pins |
| USB97CFDC | USB FLOPPY DISK CONTROLLER |
| USH-1000-KS | Lamps for Photolithography |
| USH1000FAL2 | Lamps for Photolithography |
相關代理商/技術參數 |
參數描述 |
|---|---|
| USB97C202-MN-04 | 制造商:Rochester Electronics LLC 功能描述:USB 2.0 ATA/ATAPI PERI CNTRLR - Bulk |
| USB97C202-MN-05 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| USB97C202-MV-05 | 功能描述:接口 - 專用 USB 2.0 Peripheral Cntlr RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| USB97C210 | 制造商:SMSC 制造商全稱:SMSC 功能描述:USB 2.0 FLASH MEDIA CONTROLLER |
| USB97C210-NC | 制造商:SMSC 制造商全稱:SMSC 功能描述:USB 2.0 FLASH MEDIA CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。