- 您現在的位置：買賣IC網 > PDF目錄383986 > USB97C202-MN-02 (STANDARD MICROSYSTEMS CORP) ATA/ATAPI CONTROLLER PDF資料下載
參數資料
| 型號： | USB97C202-MN-02 |
| 廠商： | STANDARD MICROSYSTEMS CORP |
| 元件分類： | 總線控制器 |
| 英文描述： | ATA/ATAPI CONTROLLER |
| 中文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP100 |
| 封裝： | 12 X 12 MM, 1.40 MM HEIGHT, STQFP-100 |
| 文件頁數： | 27/59頁 |
| 文件大?。?/td> | 385K |
| 代理商： | USB97C202-MN-02 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
SMSC DS – USB97C201
Page 27
Rev. 03/25/2002
PRELIMINARY
Table 20 – SRAM Address Register 2
SRAM_ADD2
(0XA2- RESET=0x00)
NAME
R/W
Reserved
R
SRAM_ADD
[10:8]
SRAM ADDRESS REGISTER 2
BIT
[7:3]
[2:0]
DESCRIPTION
These bits always read “0”.
This register contains upper bits
of the address in the buffer
RAM that the SRAM_DATA
register reads or writes.
R/W
Note:
These registers will auto increment upon each read or write to the SRAM_DATA register.
6.1.4.3
MCU Power Management Registers
Table 21 - MCU Clock Source Select
CLOCK_SEL
(0XA5 - RESET=0x40)
NAME
SLEEP
MCU CLOCK SOURCE SELECT
DESCRIPTION
When PCON. 0 = 1 and SLEEP has been set to 1, the
ring oscillator will be gated off, then all oscillators will be
turned off for maximum power savings.
0 = Ring Oscillator Disable.
1 = Ring Oscillator Enable. ROSC_EN must be set to 1
before the MCU can be switched to the internal Ring
Oscillator Clock source.
MCUCLK_SRC overrides MCUCLK_x clock select and
switches the MCU to the Ring Oscillator.
0 = Use Ring Oscillator. ROSC_EN must be enabled by
the MCU first.
1 = Use clock specified in MCU_CLK_[1:0]
[4:3] = 00: 3.75MHz
[4:3] = 01: 7.5MHz
[4:3] = 10: 15MHz
[4:3] = 11: 30MHz
Reflects the state of the PHY CLKVALID signal.
When 1,
indicates that the internal clocks are stable and can be
used instead of the ring oscillator.
Always reads “0”.
BIT
7
R/W
R/W
6
ROSC_EN
R/W
5
MCUCLK_SRC
R/W
[4:3]
MCU_CLK[1:0]
R/W
2
CLKVALID
R
1:0]
Reserved
R
Note 1:
The 8051 may program itself to run off of an internal Ring Oscillator having a frequency range between 8 and
24MHz. This is not a precise clock, but is meant to provide the 8051 with a clock source, without running the
30MHz crystal oscillator or the PLL
Note 2:
Switching between fast and slow clocks is recommended to save power.
Note 3:
Clock switching can be done on the fly as long as both clocks are running. When switching, it takes a total of
six clocks (3 clocks of the original clock plus 3 clocks of the switching clock) to guarantee the switching.
Note 4:
Time TBD is required from ROSC_EN=1 to MCUCLK_SRC=0.
相關PDF資料 |
PDF描述 |
|---|---|
| USB97C223 | capacitor Selection for Internal Regulator Output Pins |
| USB97C243 | capacitor Selection for Internal Regulator Output Pins |
| USB97CFDC | USB FLOPPY DISK CONTROLLER |
| USH-1000-KS | Lamps for Photolithography |
| USH1000FAL2 | Lamps for Photolithography |
相關代理商/技術參數 |
參數描述 |
|---|---|
| USB97C202-MN-04 | 制造商:Rochester Electronics LLC 功能描述:USB 2.0 ATA/ATAPI PERI CNTRLR - Bulk |
| USB97C202-MN-05 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| USB97C202-MV-05 | 功能描述:接口 - 專用 USB 2.0 Peripheral Cntlr RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| USB97C210 | 制造商:SMSC 制造商全稱:SMSC 功能描述:USB 2.0 FLASH MEDIA CONTROLLER |
| USB97C210-NC | 制造商:SMSC 制造商全稱:SMSC 功能描述:USB 2.0 FLASH MEDIA CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。