參數資料
型號： UBA1707
廠商： NXP Semiconductors N.V.
英文描述： Cordless telephone, answering machine line interface(無繩電話，電話應答機線接口)
中文描述： 無繩電話，應答機行界面（無繩電話，電話應答機線接口）
文件頁數： 16/36頁
文件大?。?/td> 245K
代理商： UBA1707
1999 Feb 17
16
Philips Semiconductors
Product specification
Cordless telephone, answering machine
line interface
UBA1707
General purpose switches (pins SWI1, SWI2 and
SWI3; bits SWC1, SWC2 and SWC3)
The UBA1707 is equipped with 3 general purpose
open-collector switches which short the pins SWI1, SWI2
and SWI3 to ground. They are respectively controlled by
bits SWC1, SWC2 and SWC3 and have an operating
voltage limited to 12 V. The outputs have to be current
biased.
For a bias current between 2 and 20 mA, the AC
impedance is 30
maximum.
Serial interface (pins DATA, CLK and EN)
A simple 3-wire unidirectional serial bus is used to program
the circuit. The 3 wires of the bus are EN, CLK and DATA.
The data sent to the device is loaded in bursts framed by
EN. Programming clock edges (falling edges) and their
appropriate data bits are ignored until EN goes active
HIGH. The programmed information is loaded into the
addressed register when EN returns inactive (LOW) or left
open-circuit.
During normal operation, EN should be kept LOW. Only
the last 8 bits serially clocked into the device are retained
within the programming register. Additional leading bits
are ignored and no check is made on the number of clock
pulses. It can always capture new programming data even
during global power-down (bit PD at logic 1).
Data is entered with the most significant bit first.
The leading 6 bits make up the data field (bits D0 to D5)
while the trailing 2 bits are the address field
(bits ADO and AD1). The first bit entered is D5, the last
bit AD0. This organisation allows to send only the number
of bits of the addressed register.
Figure 16 shows the serial timing diagram. Table 1 gives
the list of registers.
When the supply voltage V
CC
drops below 2.5 V, all
register files are set in the initial state (see Table 1) defined
by the power-up reset. At start-up, the circuit is in
power-down mode.
In the event that the IC is used in a noisy environment, it is
advised to periodically refresh the content of registers
.
相關PDF資料
PDF描述
UBA1710M Modulator for GaAs power amplifiers(應用于GaAs功率放大器的調節器)
UBA2000T Electronic TL-lamp starter(電子TL-lamp啟動器)
UBA2030T Full bridge driver IC(整橋驅動器芯片)
UBA2050 One-chip telephone ICs with speech, dialler and ringer functions(帶語音，撥號及振鈴功能的單片電話芯片)
UBA2050A One-chip telephone ICs with speech, dialler and ringer functions(帶語音，撥號及振鈴功能的單片電話芯片)
相關代理商/技術參數
參數描述
UBA1707T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Cordless telephone, answering machine line interface
UBA1707TS 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Cordless telephone, answering machine line interface
UBA1710M 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Modulator for GaAs power amplifiers
UBA2000T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Electronic TL-lamp starter
UBA2007 制造商:TI 制造商全稱:Texas Instruments 功能描述:Charge switch
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*