- 您現在的位置：買賣IC網 > PDF目錄359758 > TSC251G2DXXX-24CB IC CYCLONE III FPGA 80K 484 FBGA PDF資料下載
參數資料
| 型號： | TSC251G2DXXX-24CB |
| 英文描述： | IC CYCLONE III FPGA 80K 484 FBGA |
| 中文描述： | 微控制器 |
| 文件頁數： | 37/63頁 |
| 文件大?。?/td> | 878K |
| 代理商： | TSC251G2DXXX-24CB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁
Rev. A - May 7, 1999
37
TSC80251G2D
Notes:
1. Under steady-state (non-transient) conditions, I
OL
must be externally limited as follows:
Maximum I
OL
per port pin:.............................................10 mA
Maximum I
OL
per 8-bit port:
Port 0.................26 mA
Ports 1-3............15 mA
Maximum Total I
OL
for all:
Output Pins .......71 mA
If I
exceeds the test conditions, V
OL
may exceed the related specification. Pins are not guaranteed to sink current greater than the listed
test conditions.
2. Capacitive loading on Ports 0 and 2 may cause spurious noise pulses above 0.4 V on the low-level outputs of ALE and Ports 1, 2, and
3. The noise is due to external bus capacitance discharging into the Port 0 and Port 2 pins when these pins change from high to low. In
applications where capacitive loading exceeds 100 pF, the noise pulses on these signals may exceed 0.8 V. It may be desirable to qualify
ALE or other signals with a Schmitt Trigger or CMOS-level input logic.
3. Capacitive loading on Ports 0 and 2 causes the V
OH
on ALE and PSEN# to drop below the specification when the address lines are stabilizing.
4. Typical values are obtained using V
DD
= 3 V and T
A
= 25
°
C. They are not tested and there is not guarantee on these values.
5. The input threshold voltage of SCL and SDA meets the I
2
C specification, so an input voltage below 0.3·V
DD
will be recognized as a logic
0 while an input voltage above 0.7·V
DD
will be recognized as a logic 1.
Note:
1.
The clock prescaler is not used: F
OSC
= F
XTAL
.
Figure 12. I
DD
/I
DL
Versus X
TAL
Frequency; V
DD
= 2.7 to 3.6 V
max Active mode (mA)
typ Active mode (mA)
max Idle mode (mA)
typ Idle mode (mA)
15
10
5
0
I
D
/
D
Frequency at X
TAL(1)
(MHz)
2
4
6
8
14
10
12
16
相關PDF資料 |
PDF描述 |
|---|---|
| TSC251G2DXXX-24CED | IC CYCLONE III FPGA 80K 484 FBGA |
| TSC251G2DXXX-24IA | IC CYCLONE III FPGA 80K 484 FBGA |
| TSC251G2DXXX-24IB | IC CYCLONE III FPGA 80K 780FBGA |
| TSC251G2DXXX-L16CB | IC CYCLONE III FPGA 80K 780FBGA |
| TSC251G2DXXX-L16CED | IC CYCLONE III FPGA 80K 780FBGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSC251G2DXXX-24CE | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8/16-bit Microcontroller with Serial Communication Interfaces |
| TSC251G2DXXX-24CED | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| TSC251G2DXXX-24IA | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8/16-bit Microcontroller with Serial Communication Interfaces |
| TSC251G2DXXX-24IB | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8/16-bit Microcontroller with Serial Communication Interfaces |
| TSC251G2DXXX-L16CB | 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:8/16-bit Microcontroller with Serial Communication Interfaces |
發布緊急采購，3分鐘左右您將得到回復。