參數資料
型號： TPS65166RHAR
廠商： TEXAS INSTRUMENTS INC
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, PQCC40
封裝： 6 X 6 MM, GREEN, PLASTIC, M0-220VJJD-2, QFN-40
文件頁數： 22/45頁
文件大小： 3690K
代理商： TPS65166RHAR
Inductor Selection (Buck-Boost Converter)
Rectifier Diode Selection (Buck-Boost Converter)
Output Capacitor Selection (Buck-Boost Converter)
Positive Charge Pump Regulator (VONE)
www.ti.com.......................................................................................................................................................................................... SLVS976 – SEPTEMBER 2009
The buck-boost converter is able to operate with 10
H to 47H inductors, a 22H inductor is typical. The main
parameter for inductor selection is the saturation current of the inductor which should be higher than the peak
switch current as calculated in the Design Procedure section with additional margin to cover for heavy load
transients. The alternative more conservative approach is to choose an inductor with saturation current at least
as high as the minimum switch current limit of 1.1A. Another important parameter is the inductor dc resistance.
Usually the lower the dc resistance the higher the efficiency. The type and core material of the inductor
influences the efficiency as well. The efficiency difference among inductors can vary up to 5%. Possible inductors
are listed in Table 10.
Table 10. Inductor Selection Buck-Boost Converter
INDUCTOR VALUE
COMPONENT SUPPLIER
SIZE (LxWxH mm)
Isat/DCR
22
H
Sumida CDRH3D23/HP
4.0 × 4.0 × 2.5
0.8A/306m
22
H
Sumida CDRH4D22/HP
5.0 × 5.0 × 2.4
1.1A/214m
22
H
Sumida CDH3D13D/SHP
3.2 × 3.2 × 1.5
0.6A/753m
To achieve high efficiency, a Schottky diode should be used. The reverse voltage rating should be higher than
the maximum output voltage of the buck-boost converter. The average rectified forward current, Iavg, the Schottky
diode needs to be rated for, is equal to the output current, Iout.
Iavg = Iout
(33)
Usually a Schottky diode with a 500mA maximum average rectified forward current rating is sufficient for most
applications. The Schottky rectifier can be selected with lower forward current capability depending on the output
current Iout, but has to be able to dissipate the power. The dissipated power is the average rectified forward
current times the diode forward voltage. The efficiency rises with lower forward voltage.
PD = Iavg × Vforward
(34)
Table 11. Rectifier Diode Selection (Buck-Boost Converter)
Vr/Iavg
Vforward
RθJA
SIZE
COMPONENT SUPPLIER
40V/0.5A
0.43V at 0.5A
206°C/W
SOD-123
MBR0540, Vishay Semiconductor
40V/1A
0.42V at 0.5A
88°C/W
SMA
SS14, Fairchild Semiconductor
For the best output voltage filtering, low ESR ceramic capacitors are recommended. One 22
F or two 10F
output capacitors with sufficient voltage ratings in parallel are adequate for most applications. Additional
capacitors can be added to improve load transient regulation. See Table 12 for output capacitor selection.
Table 12. Output Capacitor Selection (Buck-Boost Converter)
CAPACITOR
COMPONENT SUPPLIER
22
F/25V
Murata, GRM32ER61E226KE15
10
F/25V
Murata, GRM31CR61E106KA12
10
F/50V
Taiyo Yuden, UMK325BJ106MM
This output rail is required to power the scan driver and is generated with a charge pump doubler stage running
from Vs and using the switch node of the boost converter. The external PNP transistor regulates the output
voltage to the programmed voltage set by the feedback resistor divider. Power dissipation and average collector
current of the transistor must be taken into consideration when choosing a suitable transistor. Also the power
dissipation of the resistor R12 must be considered.
Copyright 2009, Texas Instruments Incorporated
29
Product Folder Link(s): TPS65166
相關PDF資料
PDF描述
TPS65270RGET DUAL SWITCHING CONTROLLER, 1400 kHz SWITCHING FREQ-MAX, PQCC24
TPS65562RGTTG4 3 A BATTERY CHARGE CONTROLLER, PQCC16
TPS65735RSNR SPECIALTY ANALOG CIRCUIT, PQCC32
TPS70702PWP DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS
TPS70745PWP DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS
相關代理商/技術參數
參數描述
TPS65167ARHAR 功能描述:其他電源管理 Compact LCD Bias Sply RoHS:否 制造商:Texas Instruments 輸出電壓范圍: 輸出電流:4 mA 輸入電壓范圍:3 V to 3.6 V 輸入電流: 功率耗散: 工作溫度范圍:- 40 C to + 110 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-48 封裝:Reel
TPS65167ARHARG4 功能描述:其他電源管理 Compact LCD Bias Sply RoHS:否 制造商:Texas Instruments 輸出電壓范圍: 輸出電流:4 mA 輸入電壓范圍:3 V to 3.6 V 輸入電流: 功率耗散: 工作溫度范圍:- 40 C to + 110 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-48 封裝:Reel
TPS65167EVM-277 功能描述:電源管理IC開發工具 TPS65167 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS65167RHAR 功能描述:其他電源管理 Compact LCD Bias Supply RoHS:否 制造商:Texas Instruments 輸出電壓范圍: 輸出電流:4 mA 輸入電壓范圍:3 V to 3.6 V 輸入電流: 功率耗散: 工作溫度范圍:- 40 C to + 110 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-48 封裝:Reel
TPS65167RHARG4 功能描述:LCD 驅動器 12V/3.5A(I/O) 4-CH Multi-Converter RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*