參數資料
型號： TPS61103RGE
廠商： Texas Instruments, Inc.
英文描述： DUAL-OUTPUT, SINGLE-CELL BOOST CONVERTER
中文描述： 雙輸出，單電池升壓變換器
文件頁數： 19/28頁
文件大?。?/td> 507K
代理商： TPS61103RGE
www.ti.com
Programming the LBI/LBO Threshold Voltage
R1
R2
VBAT
VLBI-threshold
–1
390 k
VBAT
450 mV–1
(3)
VBAT
VLBI-threshold
R1
R2
1
500 mV
680 k
390 k
1
(4)
Inductor Selection
IL
IOUT
VOUT
VBAT
0.8
(5)
TPS61100, TPS61103
TPS61106, TPS61107
SLVS411B–JUNE 2002–REVISED APRIL 2004
APPLICATION INFORMATION (continued)
The current through the resistive divider should be about 100 times greater than the current into the LBI pin. The
typical current into the LBI pin is 0.01 μA, and the voltage across R2 is equal to the LBI voltage threshold that is
generated on-chip, which has a value of 400 mV, 450 mV or 500 mV. The recommended value for R2is therefore
in the range of 500 k
. From that, the value of resistor R
1
, depending on the desired minimum battery voltage
V
BAT,
can be calculated using Equation 3.
For example, if the low-battery detection circuit should flag an error condition for the 450 mV threshold on the
LBO outputs at a battery voltage of 1.23 V, a 680-k
resistor should be chosen for R1. The resulting battery
voltages of the other thresholds can be calculated using Equation 4:
The result for the 500-mV threshold in our example is 1.37 V and for the 400-mV threshold 1.1 V. This results in
the following truth table for the battery supervisor outputs:
VBAT [V]
0-1.1
1.1-1.23
1.23-1.37
1.37-VBAT max
LBO1
0
1
0
1
LBO2
0
0
1
1
If the application requires only a simple LBI/LBO function both LBO outputs can be connected together. The LBI
threshold then is 500 mV.
The outputs of the low battery supervisor are simple open-drain outputs that go active low if the dedicated battery
voltage drops below the programmed threshold voltage on LBI. The output requires a pullup resistor with a
recommended value of 1 M
. The maximum voltage which is used to pull up the LBO outputs should not exceed
the output voltage of the boost converter. If not used, the LBO pin can be left floating or tied to GND.
A boost converter normally requires two main passive components for storing energy during the conversion. A
boost inductor and a storage capacitor at the output are required. To select the boost inductor, it is
recommended to keep the possible peak inductor current below the current limit threshold of the power switch in
the chosen configuration. For example, the current limit threshold of the TPS6110x's switch is 1200 mA at an
output voltage of 3.3 V. The highest peak current through the inductor and the switch depends on the output
load, the input (V
BAT
), and the output voltage (V
OUT
). Estimation of the maximum average inductor current can be
done using Equation 5:
For example, for an output current of 100 mA at 3.3 V, at least 515 mA of current flows through the inductor at a
minimum input voltage of 0.8 V.
19
相關PDF資料
PDF描述
TPS61106RGE DUAL-OUTPUT, SINGLE-CELL BOOST CONVERTER
TPS61120 SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO
TPS612 MOSFET, P, I-PAK; Transistor type:MOSFET; Current, Id cont:15A; Resistance, Rds on:0.024R; Case style:TO-251 (I-Pak); Case style, alternate:I-PAK; Current, Idm pulse:45A; Power, Pd:30W; Transistor polarity:P; Voltage, Vds max: RoHS Compliant: Yes
TPS62020DRC 600 mA/1.25 MHz HIGH-EFFICIENCY STEP-DOWN CONVERTER
TPS62021DRC 600 mA/1.25 MHz HIGH-EFFICIENCY STEP-DOWN CONVERTER
相關代理商/技術參數
參數描述
TPS61103RGER 功能描述:直流/直流開關調節器 3.3V Hi-Eff Boost Cnvrtr w/120mA LDO RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS61103RGERG4 功能描述:直流/直流開關調節器 3.3V Hi-Eff Boost Cnvrtr w/120mA LDO RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS61106 制造商:TI 制造商全稱:Texas Instruments 功能描述:DUAL-OUTPUT, SINGLE-CELL BOOST CONVERTER
TPS61106EVM-216 功能描述:電源管理IC開發工具 TPS61106-216 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS61106PW 功能描述:直流/直流開關調節器 3.3V Hi-Eff Boost Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*