參數資料
型號: TPS40009DGQRG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10
封裝: 3.05 X 4.98 MM, GREEN, PLASTIC, MSOP-10
文件頁數: 28/28頁
文件大?。?/td> 677K
代理商: TPS40009DGQRG4
TPS40007
TPS40009
SLUS589B NOVEMBER 2003 REVISED FEBRUARY 2005
9
www.ti.com
APPLICATION INFORMATION
Detailed Description
During each switching cycle, a comparator looks at the voltage across the top side MOSFET while it is on. This
comparator is enabled after the SW node reaches a voltage greater than (VDD1.2 V) followed by a 100-ns
blanking time. If the voltage across that MOSFET exceeds the programmed voltage, the current-switching pulse
is terminated and a 3-bit counter is incremented by one count. If, during the switching cycle, the topside
MOSFET voltage does not exceed a preset threshold, then this counter is decremented by one count. (The
counter does not wrap around from 7 to 0 or from 0 to 7). If the counter reaches a full count of 7, the device
declares that a fault condition exists at the output of the converter. In this fault state, HDRV and LDRV are turned
off, and the soft-start capacitor is discharged. LDRV is maintained OFF during fault timeout to effectively support
pre-bias applications. The counter is decremented by one by the soft start capacitor (CSS) discharge. When the
soft-start capacitor is fully discharged, the discharging circuit is turned off and the capacitor is allowed to charge
up at the nominal charging rate. When the soft-start capacitor reaches approximately 1.3 V, it is discharged
again and the overcurrent counter is decremented by one count. The capacitor is charged and discharged, and
the counter decremented until the count reaches zero (a total of six times). When this happens, the outputs are
again enabled as the soft-start capacitor generates a reference ramp for the converter to follow while attempting
to restart.
During this soft-start interval (whether or not the controller is attempting to do a fault recovery or starting for the
first time), pulse-by-pulse current limiting is in effect, but overcurrent pulses are not counted to declare a fault
until the soft-start cycle has been completed. It is possible to have a supply attempt to bring up a short circuit
for the duration of the soft start period plus seven switching cycles. Power stage designs should take this into
account if it makes a difference thermally. Figure 3 shows the details of the overcurrent operation.
UDG03165
0V
VTS
Overcurrent
Cycle
Normal
Cycle
Internal PWM
External
Main Drive
Short Circuit Protection
Threshold Voltage
(+)
VTS
()
Figure 3. Short Circuit Operation
相關PDF資料
PDF描述
TPS40022PWP 0.01 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40022PWPR 0.01 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40042DRCTG4 SWITCHING CONTROLLER, 700 kHz SWITCHING FREQ-MAX, PDSO10
TPS40055MPWPREPG4 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40055QPWPRQ1 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
TPS40009EVM-001 功能描述:電源管理IC開發工具 TPS40009-001 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS40020 制造商:TI 制造商全稱:Texas Instruments 功能描述:ENHANCED LOW INPUT VOLTAGE MODE SYNCHRONOUS BUCK CONTROLLER
TPS40020PWP 功能描述:DC/DC 開關控制器 Enhanced Low Input RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40020PWPG4 功能描述:DC/DC 開關控制器 Enh Lo Input Freq Sync. Buck Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40020PWPR 功能描述:DC/DC 開關控制器 Enh Lo Input Freq Sync. Buck Cntrlr RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK