參數資料
型號: TMC2005
廠商: STANDARD MICROSYSTEMS CORP
元件分類: 網絡接口
英文描述: 5 Port HUB Controller Device
中文描述: DATACOM, NETWORK INTERFACE SUPPORT CIRCUIT, PQFP60
封裝: QFP-60
文件頁數: 11/32頁
文件大?。?/td> 153K
代理商: TMC2005
SMSC DS – TMC2005
Page 11
Rev. 10/24/2000
OPERATIONAL DESCRIPTION
Direction Determination
All TX ports are set to disable mode in the initial state. When a signal is received from any RX ports, the circuit
holds the port on receiving mode (disable TX) and changes the other ports to sending mode (disable RX). One
port stays in RX and the rest change into TX after all. The circuit initializes the internal DPLL on the timing of
received RX pulse, and the RX buffer circuit stores the RX data and filters its jitter. TX controlling circuit regenerates
the stored RX pulse on nPULSE1, nPULSE2 and nP1BAK. The nPULSE1 and nPULSE2 are pulse output pins for
transceivers (HYC9068S-SK/9088S-SK) of ARCNET normal mode. The nP1BAK is a pulse output pin for
transceiver (HYC2485S/2488S and RS485 driver) of ARCNET back plane mode. When using optical transceiver,
instead of these signals, TXENA [0:1], TXENB [0:1], EXTTX (MA, MB, ME = 0) must be used as TX data inputs of the
optical transceiver.
Direction Release
On ARCNET protocol, each TX message starts with 6-bits of “1” ALERT and each data byte is lead by three bits (1,
1, 0) preamble. To control the HUBs direction, the circuit monitors this bit pattern and holds the state. If the end of
the bit pattern comes, all TX ports return receiving mode (disable TX) again. The interval timer detects the end of
the bit pattern. During data is on line, silent period is less than 4 uS* because at least one bit “1” among 10-bits is
received while receiving the data. The minimum silent interval from the end of received data to the alert of the next
data (the minimum time of changing the direction) is the chip turn around time (12.6 uS*) of ARCNET controller.
The interval timer to detect the data end is set to 5.6uS by adding some margin to the above interval for neglecting
the reflection on a cable.
[Note] Numbers marked * are at 2.5Mbps operation.
Jitter Filter
To build a network with transceivers that introduce big jitter like ones for optical fiber, the old HUB that has direction
control only may cause a transmission error because jitters on each HUB are added when several HUBs were
connected in serial. The TMC2005 fixes that problem with jitter filtering and wave shaping through the following
three steps.
1) Input Sampling
The TMC2005 samples a data on a network by eight times clock of the network data.
2) Jitter Filtering (DPLL)
The TMC2005 filters the jitter (± 100nS at 2.5Mbps) of network data sampled by 8X clock through the internal digital
PLL and stores the data into the buffer.
3) Wave Shaping Output
The TMC2005 re-synchronizes and regenerates the network data at the same clock as the data rate.
The capability of the jitter filtering is shown below.
DATA RATE
10Mbps
5Mbps
2.5Mbps
1.25Mbps
625Kbps
312.5Kbps
156.25Kbps
CAPABILITY OF JITTER FILTERING
± 25nS
± 50nS
± 100nS
± 200nS
± 400nS
± 800nS
± 1.6uS
相關PDF資料
PDF描述
TMC20073-NT Circular Connector; Body Material:Aluminum; Series:PT07; Number of Contacts:7; Connector Shell Size:22; Connecting Termination:Crimp; Circular Shell Style:Jam Nut Receptacle; Circular Contact Gender:Pin; Insert Arrangement:22-96
TMC20073 CIRCLINK COMMUNICATIONS CONTROLLER LSI
TMC2081 Digital Video Mixer(數字視頻混頻器)
TMC2192 10 Bit Video Encoder(10位視頻編碼器)
TMC22151A 8-Bit/10-Bit Digital Video Decoder(8位/10位數字視頻譯碼器)
相關代理商/技術參數
參數描述
TMC2005-JT 功能描述:接口 - 專用 5 Port Hub Contrllr RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59
TMC20073 制造商:SMSC 制造商全稱:SMSC 功能描述:CIRCLINK COMMUNICATIONS CONTROLLER LSI
TMC-20073 制造商:Microchip Technology Inc 功能描述:ARCNET CONTROLLER
TMC20073-NT 制造商:SMSC 制造商全稱:SMSC 功能描述:CIRCLINK COMMUNICATIONS CONTROLLER LSI
TMC200A 制造商:TOPSTEK 制造商全稱:TOPSTEK 功能描述:Topstek Current Transducer