參數資料
型號: TLE6208-3G
廠商: INFINEON TECHNOLOGIES AG
英文描述: Triple-Half-Bridge
中文描述: 三半橋
文件頁數: 5/21頁
文件大?。?/td> 198K
代理商: TLE6208-3G
TLE 6208-3 G
Data Sheet
5
2001-05-10
1.5
Circuit Description
Figure 2
shows a block schematic diagram of the module. There are 3 halfbridge drivers
on the right-hand side. An HS driver and an LS driver are combined to form a halfbridge
driver in each case. The drivers communicate via the internal data bus with the logic and
the other control and monitoring functions: undervoltage (UV), overvoltage (OV),
overtemperature (TSD), charge pump and fault detect.
Two connection interfaces are provided for supply to the module: All power drivers are
connected to the supply voltage
V
S
. These are monitored by overvoltage and
undervoltage comparators with hysteresis, so that the correct function can be checked
in the application at any time.
The logic is supplied by the
V
CC
voltage, typ. with 5 V. The
V
CC
voltage uses an internally
generated Power-On Reset (POR) to initialize the module at power-on. The advantage
of this system is that information stored in the logic remains intact in the event of short-
term failures in the supply voltage
V
S
. The system can therefore continue to operate
following
V
S
undervoltage, without having to be reprogrammed. The
undervoltage
information is stored, and can be read out via the interface. The same logically applies
for overvoltage.
Interference spikes
on
V
S
are therefore effectively suppressed.
The situation is different in the case of undervoltage on the
V
CC
connection pin. If this
occurs, then the internally stored data is deleted, and the output levels are switched to
high-impedance status (tristate). The module is initialized by
V
CC
following restart
(Power-On Reset = POR).
The 16-bit wide programming word or control word (see
Table Input Data Protocol
) is
read in via the DI data input, and this is synchronized with the clock input CLK. The status
word appears synchronously at the DO data output (see
Table
Diagnosis Data
Protocol
). It is also possible to connect two
TLE 6208-3 G
in a daisy chain configuration.
The DO data output of one device is connected with the DI data input of the second
device. In this configuration these two devices are controlled with a single CSN chip
select and using a 32-bit wide control word.
The transmission cycle begins when the chip is selected with the CSN input (H to L). If
the CSN input changes from L to H then the word which has been read in becomes the
control word. The DO output switches to tristate status at this point, thereby releasing the
DO bus circuit for other uses.
The INH inhibit input can be used to cut off the complete module. This reduces the
current consumption to just a few
μ
A, and results in the loss of any data stored. The
output levels are switched to tristate status. The module is reinitialized with the internally
generated POR (Power-On Reset) at restart.
This feature allows the use of this module in battery-operated applications (vehicle body
control applications).
相關PDF資料
PDF描述
TLE6208-6 Hex-Half-Bridge / Double Six-Driver
TLE6208-6G Hex-Half-Bridge / Double Six-Driver
TLE6210 ABS System IC
TLE6210C ABS System IC
TLE6210G ABS System IC
相關代理商/技術參數
參數描述
TLE6208-3-G 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Triple-Half-Bridge
TLE6208-3G_07 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Triple Half Bridges Optimized for DC motor management applications
TLE62083GXUMA1 制造商:Infineon Technologies AG 功能描述:Triple Half Bridge Motor Driver 14-Pin DSO 制造商:Infineon Technologies AG 功能描述:BODY BRIDGES - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC MOTOR DRIVER SPI 14DSO
TLE6208-6 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Hex-Half-Bridge / Double Six-Driver
TLE62086G 制造商:Rochester Electronics LLC 功能描述: 制造商:Infineon Technologies AG 功能描述: