- 您現在的位置：買賣IC網 > PDF目錄384985 > TLE5226G (SIEMENS A G) Smart Quad Channel Low-Side Switch PDF資料下載
參數資料
| 型號： | TLE5226G |
| 廠商： | SIEMENS A G |
| 元件分類： | 外設及接口 |
| 英文描述： | Smart Quad Channel Low-Side Switch |
| 中文描述： | 5 A BUF OR INV BASED PRPHL DRVR, PDSO20 |
| 文件頁數： | 7/13頁 |
| 文件大?。?/td> | 196K |
| 代理商： | TLE5226G |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁
TLE 5226 G
Semiconductor Group
Page
1998-02-04
7
Application Description
This IC is especially designed to drive inductive loads (relays, electromagnetic valves).
Integrated clamp-diodes limit the output voltage when inductive loads are discharged.
Four open-drain logic outputs indicate the status of the integrated ciruit. The following conditions are
monitored and signalled:
- overloading of output (also shorted load to supply) in active mode
- open and shorted load to ground in active and inactive mode
- overtemperature
Circuit Description
Input Circuits
The control and enable inputs, both active high, consist of schmitt triggers with hysteresis. All inputs
are connected with pull-down current sources. Not connected inputs are interpreted as LOW.
In standby mode (STBY = LOW ) the current consumption is greatly reduced. The circuit is active
when STBY = HIGH.
If the standby function is not used, it is allowed to connect the standby pin directly to V
S
.
Switching Stages
The four power outputs consist of DMOS-power transistors with open drains. The output stages are
shorted loads protected throughout the operating range. Integrated clamp-diodes limit voltage
overshoots produced when inductive loads are demagnetized.
Parallel to the DMOS transistors there are internal pull down resistors. They are provided to detect an
open load condition in the off state. They will be disconnected in the standby mode.
Protective Circuits
The outputs are protected against current overload and overtemperature.
There is no protection against reverse polarity of the supply voltage.
Error Detection
The status outputs indicate the switching state under normal conditions (LOW = off; HIGH = on). If an
error occurs, the logic level of the status output is inverted, as listed in the diagnostic table below.
The state of the error detection circuits is directly dependent on the input status.
If current overload or overtemperature occurs, the error condition is stored into an internal register and
the output is shutdown. The reset is done by switching off the corresponding control input.
相關PDF資料 |
PDF描述 |
|---|---|
| TLFD600 | GT 4C 2#8 2#16 PIN RECP WALL |
| TLFGE1002A | TOSHIBA LED LAMP |
| TLGE1002A | TOSHIBA LED LAMP |
| TLOE1002A | TOSHIBA LED LAMP |
| TLSE1002A | TOSHIBA LED LAMP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TLE5250 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:2.5-A High Performance Smart Power Stepper-Motor Driver with Diagnostic Interface |
| TLE6208-3G | 功能描述:馬達/運動/點火控制器和驅動器 Triple-Half-Bridge RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| TLE6208-3-G | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Triple-Half-Bridge |
| TLE6208-3G_07 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Triple Half Bridges Optimized for DC motor management applications |
| TLE62083GXUMA1 | 制造商:Infineon Technologies AG 功能描述:Triple Half Bridge Motor Driver 14-Pin DSO 制造商:Infineon Technologies AG 功能描述:BODY BRIDGES - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC MOTOR DRIVER SPI 14DSO |
發布緊急采購，3分鐘左右您將得到回復。