- 您現在的位置：買賣IC網 > PDF目錄361460 > TISP61060P (Power Innovations International, Inc.) DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS PDF資料下載
參數資料
| 型號： | TISP61060P |
| 廠商： | Power Innovations International, Inc. |
| 英文描述： | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| 中文描述： | 雙遠期導電的P -可編程門晶閘管過壓保護 |
| 文件頁數： | 9/14頁 |
| 文件大?。?/td> | 286K |
| 代理商： | TISP61060P |
9
SEPTEMBER 1995 - REVISED SEPTEMBER 1997
TISP61060D, TISP61060P
DUAL FORWARD-CONDUCTING P-GATE THYRISTORS
PROGRAMMABLE OVERVOLTAGE PROTECTORS
P R O D U C T I N F O R M A T I O N
energy capability. Second, the series gate diodes have been changed to transistor buffers. The maximum
current injected into the gate supply is then reduced by the transistors gain factor (H
FE
). Third, some current
from the positive voltage diode conduction has been diverted to the gate terminal which subtracts from the
normal gate current. In most cases, this allows any previously used SLIC supply rail shunt protection diode to
be removed. Although the SLIC supply is taken to a terminal that is internally connected to transistor bases,
the terminal is still designated as the gate terminal, G.
Figure 6 shows the high impedance a.c. waveforms for the TISP61060. As the TISP61060 replaces the IC
based protector’s gate diode with a transistor, the peak gate current is reduced by over 50 times. In addition
there is a compensating negative gate current flow during diode conduction. The TISP61060 has the
maximum value of peak gate current specified and so allows for designer to design for limit conditions. Most
IC protectors do not specify this parameter. Figure 7 shows the improvement due to the TISP61060. These
plots show the full cycle average gate current against rms a.c. voltage. The IC based protector has a
substantial positive gate current which will always charge the SLIC supply, possibly causing an overvoltage.
The TISP61060 has a negative gate current and so cannot overvoltage the SLIC.
Figure 6. TISP61060 HIGH IMPEDANCE POWER CROSS CLIPPING WAVE FORMS
Time - ms
0
5
10
15
20
IK
-300
-200
-100
0
100
200
300
IG
-10
-8
-6
-4
-2
0
2
4
6
8
10
Time - ms
0
5
10
15
20
V
-60
-50
-40
-30
-20
-10
0
10
V
G
V
K
I
K
I
G
I
G
I
K
AI6XAI
相關PDF資料 |
PDF描述 |
|---|---|
| TISP61089A | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089SDR | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089S | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089SD | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089 | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP61060PS | 制造商:Bourns Inc 功能描述: |
| TISP61060P-S | 功能描述:SCR RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089 | 制造商:POINN 制造商全稱:Power Innovations Ltd 功能描述:DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089A | 制造商:POINN 制造商全稱:Power Innovations Ltd 功能描述:DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089AD | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。