- 您現在的位置：買賣IC網 > PDF目錄361460 > TISP61060P (Power Innovations International, Inc.) DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS PDF資料下載
參數資料
| 型號： | TISP61060P |
| 廠商： | Power Innovations International, Inc. |
| 英文描述： | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| 中文描述： | 雙遠期導電的P -可編程門晶閘管過壓保護 |
| 文件頁數： | 11/14頁 |
| 文件大小： | 286K |
| 代理商： | TISP61060P |
11
SEPTEMBER 1995 - REVISED SEPTEMBER 1997
TISP61060D, TISP61060P
DUAL FORWARD-CONDUCTING P-GATE THYRISTORS
PROGRAMMABLE OVERVOLTAGE PROTECTORS
P R O D U C T I N F O R M A T I O N
TISP61060 a.c. ratings. As covered earlier, the gate decoupling capacitor should be 100 nF and should be
mounted as close to the protector as possible.
application circuit
Figure 8 shows a typical TISP61060 SLIC card protection circuit. The incoming line wires, R and T, connect to
the relay matrix via the series over-current protection. Fusible resistors, fuses and positive temperature
coefficient (PTC) resistors can be used for over-current protection. Resistors will reduce the prospective
current from the surge generator for both the TISP61060 and the ring/test protector. The TISP7xxxF3
protector has the same protection voltage for any terminal pair. This protector is used when the ring generator
configuration maybe ground or battery-backed. For dedicated ground-backed ringing generators, the
TISP3xxxF3 gives better protection as its inter-wire protection voltage is twice the wire to ground value.
Relay contacts 3a and 3b connect the line wires to the SLIC via the TISP61060 protector. The protector gate
reference voltage comes from the SLIC negative supply (V
BAT
). A 100 nF gate capacitor sources the high
gate current pulses caused by fast rising impulses.
Figure 8. TYPICAL APPLICATION CIRCUIT
TEST
RELAY
RING
RELAY
SLIC
RELAY
TEST
EQUIP-
MENT
RING
GENERATOR
S1a
S1b
R1
R2
RING
WIRE
TIP
WIRE
Th1
Th2
Th3
Th4
Th5
SLIC
SLIC
PROTECTOR
RING/TEST
PROTECTION
OVER-
CURRENT
PROTECTION
S2a
S2b
TISP
61060
TISP
3xxxF3
OR
7xxxF3
S3a
S3b
V
BAT
100 nF
AI6XAF
相關PDF資料 |
PDF描述 |
|---|---|
| TISP61089A | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089SDR | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089S | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089SD | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089 | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP61060PS | 制造商:Bourns Inc 功能描述: |
| TISP61060P-S | 功能描述:SCR RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089 | 制造商:POINN 制造商全稱:Power Innovations Ltd 功能描述:DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089A | 制造商:POINN 制造商全稱:Power Innovations Ltd 功能描述:DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP61089AD | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。