- 您現在的位置：買賣IC網 > PDF目錄98229 > THS8083-95CPZP (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, PQFP100 PDF資料下載
參數資料
| 型號： | THS8083-95CPZP |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP100 |
| 封裝： | POWER, THERMALLY ENHANCED, PLASTIC, TQFP-100 |
| 文件頁數： | 13/61頁 |
| 文件大?。?/td> | 239K |
| 代理商： | THS8083-95CPZP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
2–6
The PFD also provides a LOCK output on a dedicated output terminal. This output has a programmable hysteresis
(LD_THRES register value). Details are explained in the section that describes the register map of this device. The
LOCK output is made available on a dedicated pin so that the user could implement additional functionality before
using this output (e.g., implement sticky nature of an unlock condition by routing it through an external set/reset
flip-flop).
By integrating the loop filter and making it programmable, the user can trade off both at runtime depending on the
quality of the incoming HS signal (inaccurate frequency, jitter content).
The filtered phase/frequency error value is now used to correct the programmed nominal DTO increment (NOM_INC
register value) to the instantaneous DTO increment (DTO_INC reported value). This updated DTO increment
determines the instantaneous DTO output frequency. By making DTO_INC available as a read-only register, the user
can read out via I2C and calculate the instantaneous frequency of the DTO generated clock.
Because of the digital nature of the PLL, the loop can be opened while still keeping an accurate frequency output.
Therefore, the PLL can also be used as a frequency synthesizer, without any HS reference. This is done by disabling
the PFD (PFD_DISABLE register value). This will keep DTO_INC always equal to NOM_INC, thereby producing a
DTO output frequency always equal to the desired programmed frequency, irrespective of HS.
There is a second option to operate in open loop though. In some video/graphics modes no valid HS is present during
a part of the frame/field period, typically during some lines of the VBI (vertical blanking interval). In order to have an
accurate PLL output clock and avoid clock drift, the PFD output needs to be held constant during this time. The PFD
FREEZE pin provides this option. Asserting this will freeze DTO_INC to its present value, thereby producing a
constant PLL output clock frequency, not necessarily equal to the nominal desired frequency programmed by
NOM_INC. Together with the composite sync slicer, this feature allows the use of the PLL for input signals with
embedded composite sync with minimal external logic. See Composite Sync Slicer section.
The phase of the PLL generated clock can be programmed in 31 uniform steps over a single clock period
(360/31 = 11.6 degrees phase resolution) so that the sampling phase of the ADC’s can be controlled accurately.
Next to sourcing the ADC channel clock from the PLL, the option exists to use an external pixel clock (from terminal
EXT_ADCCLK). If configured this way (via SEL_ADCCLK register value), a clock signal of the required sampling
frequency should be applied to EXT_ADCCLK and this signal, instead of the PLL generated clock, is routed to the
ADC channels. No phase control is available in this case on the external clock signal. Still, the internal PLL can be
used and its output available externally as explained below. This means two clock domains can be implemented on
THS8083: a first one from externally fed, a second one, possibly asynchronous to the first, generated by the internal
PLL. This provides considerable flexibility in the design of video/graphics equipment that implements scaling and
frame rate conversion.
相關PDF資料 |
PDF描述 |
|---|---|
| THS8083APZP | SPECIALTY CONSUMER CIRCUIT, PQFP100 |
| THS8083APZPG4 | SPECIALTY CONSUMER CIRCUIT, PQFP100 |
| THS8083CPZP | SPECIALTY CONSUMER CIRCUIT, PQFP100 |
| THS8133ACPHP | PARALLEL, WORD INPUT LOADING, 0.005 us SETTLING TIME, 10-BIT DAC, PQFP48 |
| THS8133BCPHP | PARALLEL, WORD INPUT LOADING, 0.005 us SETTLING TIME, 10-BIT DAC, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS8083A | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TRIPLE 8 BIT 80 MSPS 3.3V VIDEO AND GRAPHICS |
| THS8083A95 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:TRIPLE 8-BIT, 95MSPS, 3.3V VIDEO AND GRAPHICS |
| THS8083A95PZP | 功能描述:視頻模擬/數字化轉換器集成電路 Tr 8B 95MSPS 3.3V Vid & Graphics Dig RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
| THS8083APZP | 功能描述:視頻模擬/數字化轉換器集成電路 Triple 8B 80 MSPS 3.3V YUV/RGB RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
| THS8083APZP | 制造商:Texas Instruments 功能描述:8BIT ADC 80MSPS TRIPLE SMD 8083 |
發布緊急采購，3分鐘左右您將得到回復。