參數資料
型號： THS770012IRGET
廠商： TEXAS INSTRUMENTS INC
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, PQCC24
封裝： GREEN, PLASTIC, VQFN-24
文件頁數： 9/35頁
文件大?。?/td> 1305K
代理商： THS770012IRGET
SLOS669B
– FEBRUARY 2010 – REVISED MAY 2011
Power-Down
The standard EVM is used with T1 and T2 removed, jumpers placed across terminals 3 to 4 and 1 to 6, R15 and
R17 = 49.9
, C9 and C13 = 0, and R5, R6, R16, and R21 = open. A waveform generator is connected to the
power-down input of the EVM with a 50
coaxial cable at J8. The differential output at J3 and J4 is connected
with 50
coaxial cables to an oscilloscope to measure the outputs. J1 is left disconnected so that the output is
driven to the VOCM voltage when the device is active, and discharged through the resistive load on the output
when disabled. Both outputs are the same and only one is shown.
Differential Z-out
The standard EVM is used with R15 and R17 = 24.9
, and R16 = open. A network analyzer is connected to the
output of the EVM at J3 with 50
coaxial cable, both inputs are terminated with a 50 load, and a
high-impedance differential probe is used for the measurement. The analyzer is set to measure the forward
transfer function (s21). The analyzer with probe input is calibrated across the open resistor pads of R16 and the
signal is measured at the output pins of the device. The output impedance is calculated using the known resistor
values and the attenuation caused by R15 and R17.
Output Balance Error
The standard EVM is used with R15 and R17 = 100
, and R16 = 0. A network analyzer is connected to the
input of the EVM with 50
coaxial cable, the output is left open, and a high-impedance differential probe is used
for the measurement. The analyzer is set to measure the forward transfer function (s21). The analyzer with probe
input is calibrated at the input pins of the device and the signal is measured from the shorted pads of R16 to
ground.
Common-Mode Rejection
The standard EVM is used with T1 removed and jumpers place across terminals 3 to 4, 1 to 6, and 1 to 3. A
network analyzer is connected to the input and output of the EVM with 50
coaxial cable and set to measure the
forward transfer function (s21).
VOCM Frequency Response
The standard EVM is used with T2 removed and jumpers across terminals 3 to 4 and 1 to 6; R10, R15, and
R17 = 49.9
; C3 and C4 = 0; and R9, R16, and R21 = open. A network analyzer is connected to the VOCM
input of the EVM at J7 and output of the EVM with 50
coaxial cable, and set to measure the forward transfer
function (s21). The input signal frequency is swept with the signal level set for 200mV. Each output at J3 and J4
is measured as single-ended, and because both are the same, only one output is shown.
VOCM Slew Rate and Pulse Response
The standard EVM is used with T2 removed and jumpers across terminals 3 to 4 and 1 to 6; R10, R15, and
R17 = 49.9
; C9 and C13 = 0; and C3, C4, R9, R16, and R21 = open. A waveform generator is connected to
the VOCM input of the EVM at J7 with 50 coaxial cable. The differential output at J3 and J4 is connected with
50
coaxial cable to an oscilloscope to measure the outputs. J1 is left disconnected so that the output is driven
to the VOCM voltage. Both outputs are the same, so only one is shown.
Input/Output Voltage Noise, Settling Time, and Power-Supply Rejection
These parameters are taken from simulation.
Copyright
2010–2011, Texas Instruments Incorporated
17
相關PDF資料
PDF描述
THS8083-95CPZP SPECIALTY CONSUMER CIRCUIT, PQFP100
THS8083APZP SPECIALTY CONSUMER CIRCUIT, PQFP100
THS8083APZPG4 SPECIALTY CONSUMER CIRCUIT, PQFP100
THS8083CPZP SPECIALTY CONSUMER CIRCUIT, PQFP100
THS8133ACPHP PARALLEL, WORD INPUT LOADING, 0.005 us SETTLING TIME, 10-BIT DAC, PQFP48
相關代理商/技術參數
參數描述
THS788 制造商:TI 制造商全稱:Texas Instruments 功能描述:QUAD-CHANNEL TIME MEASUREMENT UNIT (TMU)
THS788PFD 功能描述:計時器和支持產品 Quad Ch Time Msmt Unit RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
THS788PFDT 功能描述:計時器和支持產品 Quad Ch Time Msmt Unit RoHS:否 制造商:Micrel 類型:Standard 封裝 / 箱體:SOT-23 內部定時器數量:1 電源電壓-最大:18 V 電源電壓-最小:2.7 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Reel
THS789PFD 制造商:Texas Instruments 功能描述:Time Measurement Unit (TMU) 100-Pin HTQFP EP Tray 制造商:Texas Instruments 功能描述:IC TIME MEASUREMNT UNIT 100HTQFP 制造商:Texas Instruments 功能描述:THS789PFD
THS7BAT 功能描述:電池組 Rechargeable NICD For THS700 series RoHS:否 制造商:Ultralife 電池大小: 電池?cái)?shù)量: 輸出電壓:3.7 V 容量: 化學性質:Lithium 端接類型:Wire
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*