- 您現在的位置：買賣IC網 > PDF目錄382587 > THS1060C (Texas Instruments, Inc.) 10-BIT 60 MSPS IF SAMPLING COMMUNICATIONS ANALOG-TO-DIGITAL CONVERTER PDF資料下載
參數資料
| 型號： | THS1060C |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 10-BIT 60 MSPS IF SAMPLING COMMUNICATIONS ANALOG-TO-DIGITAL CONVERTER |
| 中文描述： | 10位60 MSPS的IF采樣通訊模擬到數字轉換器 |
| 文件頁數： | 17/21頁 |
| 文件大?。?/td> | 353K |
| 代理商： | THS1060C |
THS1060
10-BIT 60 MSPS IF SAMPLING COMMUNICATIONS
ANALOG-TO-DIGITAL CONVERTER
SLAS212 – MARCH 2000
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
using the analog input
The THS1060 obtains optimum performance when the analog signal inputs are driven differentially. The circuit
below shows the optimum configuration, see Figure 23. The signal is fed to the primary of an RF transformer.
Since the input signal must be biased around the common mode voltage of the internal circuitry, the common
mode (V
CM
) reference from the THS1060 is connected to the center-tap of the secondary. To ensure a steady
low noise V
CM
reference the best performance is obtained when the V
CM
output is connected to ground with
a 0.1
μ
F and 0.01
μ
F low inductance capacitor.
R
50
VIN+
VCM
THS1060
0.01
μ
F
0.1
μ
F
50
1:1
VIN–
ac Signal
T1-1T
Figure 23. THS1060 With Coaxial Feed
When it is necessary to buffer or apply a gain to the incoming analog signal, it is also possible to combine a
single-ended amplifier with an RF transformer as shown in Figure 24. For this application, a wide-band current
mode feedback amplifier such as the THS3001 is best. The single ended output allows the use of standard
passive filters between the amplifier output and the primary. In this case, the SFDR of the op amp is not as critical
as that of the A/D converter. While harmonics generated from within the A/D converter fold back into the first
Nyquist zone, harmonics generated externally in the op amps can be filtered out with passive filters.
VIN+
VIN–
VCM
THS1060
0.1
μ
F
0.01
μ
F
_
+
BPF
10
1 k
1 k
RT
IF Input
THS3001
Impedance Ratio = 1:n
Figure 24. IF Input Buffered with THS3001 Op Amp
相關PDF資料 |
PDF描述 |
|---|---|
| THS1060I | 10-BIT 60 MSPS IF SAMPLING COMMUNICATIONS ANALOG-TO-DIGITAL CONVERTER |
| THS1401PFB | Labels; External Height:2.75"; External Width:1."; Label Material:Polyester |
| THS1403PFB | 14-BIT, 1/3/8 MSPS DSP COMPATIBLE ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE AND PGA |
| THS1408PFB | 14-BIT, 1/3/8 MSPS DSP COMPATIBLE ANALOG-TO-DIGITAL CONVERTERS WITH INTERNAL REFERENCE AND PGA |
| THS3125CPWPRG4 | LOW-NOISE, HIGH-SPEED, 450 mA CURRENT FEEDBACK AMPLIFIERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| THS1060CPHP | 功能描述:模數轉換器 - ADC Desc Unavailable RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| THS1060I | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT 60 MSPS IF SAMPLING COMMUNICATIONS ANALOG-TO-DIGITAL CONVERTER |
| THS1060IPHP | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| THS1060PHP | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT 60 MSPS IF SAMPLING COMMUNICATIONS ANALOG-TO-DIGITAL CONVERTER |
| THS10680RJ | 功能描述:線繞電阻器 - 底架安裝 THS10 680R 5% RoHS:否 制造商:Vishay/Dale 電阻:7 Ohms 容差:1 % 功率額定值:100 W 溫度系數:50 PPM / C 系列:RH 工作溫度范圍:- 55 C to + 250 C 尺寸:46.02 mm Dia. x 46.02 mm W x 88.9 mm L x 44.45 mm H 封裝:Bulk 產品:Power Resistors Wirewound Aluminum Housed |
發布緊急采購，3分鐘左右您將得到回復。