- 您現在的位置：買賣IC網 > PDF目錄383943 > TEA1541 (NXP Semiconductors N.V.) SMPS control IC with synchronization function PDF資料下載
參數資料
| 型號： | TEA1541 |
| 廠商： | NXP Semiconductors N.V. |
| 英文描述： | SMPS control IC with synchronization function |
| 中文描述： | 開關電源與同步功能控制IC |
| 文件頁數： | 8/19頁 |
| 文件大小： | 112K |
| 代理商： | TEA1541 |
2003 Aug 11
8
Philips Semiconductors
Product specification
SMPS control IC with
synchronization function
TEA1541
6.3
Primary current regulation
The IC uses current mode control for its good line
regulation behaviour. The primary current is sensed
indirectly via the voltage at pin DEM.
The ‘on-time’ of the external MOSFET is controlled by the
voltage on pin CTRL which is compared with the internal
simulated primary current information. For pin CTRL
voltages (V
CTRL
) between 1 and 1.6 V, the on-time is
calculated by the equation:
1.6
V
–
I
DEM
where:
t
on
: the on-time
α
PCS
: an internal constant which is approximately 0.9.
V
CTRL
: the voltage on pin CTRL
I
DEM
:thecurrentdrawnfrompin DEMduringtheprimary
cycle.
6.4
Oscillator
In synchronized mode, the switching frequency of the
SMPS f
smps
is controlled by the synchronizing pulses f
sync
at pin CTRL. Synchronized mode prevents noise
disturbance on the CRT monitor screen. Synchronizing
pulses whose frequency is outside of the f
osc
and f
smps(max)
window of 26 to 54 kHz are divided by an internal
frequency divider. A small frequency hysteresis exists to
ensure a stable frequency switch-over. In unsynchronized
mode, the system runs at f
osc
(26 kHz). In unsynchronized
mode, at very low power (standby) levels, the frequency of
the VCO and consequently the SMPS switching frequency
is reduced linearly to its low value of approximately 6 kHz
(see Figs 4 and 6).
6.5
Demagnetization
The system always operates in discontinuous conduction
mode to ensure demagnetization of the output transformer
core. A primary cycle only starts when the secondary cycle
has ended.
Pin DEM protects against an output short-circuit on a
cycle-by-cycle basis, by immediately lowering the
switching frequency to give a longer off-time and a lower
operating power.
Demagnetization detection is suppressed automatically at
the start of each secondary cycle for a period t
suppr
.
Suppressionofdemagnetizationdetectionisnecessaryfor
applications where the transformer has a large leakage
inductance, at low output voltages and at start-up.
If, due to a fault condition, pin DEM is left open circuit,
operation of the flyback converter supply immediately
stops, and restarts when the fault situation is removed and
pin DEM is reconnected.
If, during start-up, a fault condition causes pin DEM to be
shorted to ground, operation of the flyback converter
supply stops after the first cycle, and the IC then begins a
restart cycle. This situation continues until the short-circuit
is removed. Short-circuit protection is also active at full
power to ensure limitation of peak current.
t
on
α
PCS
------------------------------
×
ns
[
]
=
handbook, halfpage
MDB086
f
(kHz)
fsmps(max)
fsync
(min)
2
×
fsync
(max)
fsync
(max)
fosc
Fig.6
Switching frequency as a function of the
synchronizing frequency.
相關PDF資料 |
PDF描述 |
|---|---|
| TEA1541P | SMPS control IC with synchronization function |
| TEA1552 | GreenChipII SMPS control IC |
| TEA5594 | AM/FM radio receiver circuit |
| TEA5710TD-T | AM/FM Receiver Circuit |
| TEA5711N | Transient Voltage Suppressor Diodes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TEA1541P | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:SMPS control IC with synchronization function |
| TEA1551T/N1,518 | 制造商:NXP Semiconductors 功能描述:OTHERS |
| TEA1552 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GreenChipII SMPS control IC |
| TEA1552T | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:GreenChipII SMPS control IC |
| TEA1552T/N1 | 制造商:NXP Semiconductors 功能描述:AC-DC SMPS 14SOIC 制造商:NXP Semiconductors 功能描述:AC-DC, SMPS, 14SOIC |
發布緊急采購，3分鐘左右您將得到回復。