參數資料
型號： TDA8722M-T
廠商： NXP SEMICONDUCTORS
元件分類： 消費家電
英文描述： SPECIALTY CONSUMER CIRCUIT, PDSO20
文件頁數： 10/28頁
文件大?。?/td> 155K
代理商： TDA8722M-T
1998 Jun 23
18
Philips Semiconductors
Product specication
I2C-bus programmable modulator for
negative video modulation and FM sound
TDA8722
Modulation depth
With 500 mV (peak-to-peak value) video input signal, the
wanted modulation depth must be set by the value of R17
(resistor between pin 17 and ground) as shown Fig.10. For
a good accuracy, it is recommended to use a 1% type
resistor.
It is also possible to use an adjustable resistor, see Fig.8.
Depending on the layout of the PCB, it may be necessary
to slightly change the value of R17 from the one given in
Fig.10 to get the wanted modulation depth.
Sound oscillator design
The frequency of the sound subcarrier is fixed by the tank
circuit connected between pins 2 and 3. This frequency
can be adjusted between 4.5 and 6.5 MHz covering all
existing standards in the world.
The damping resistor R3 between pins 2 and 3 is
necessary to decrease the quality factor of the tank circuit
allowing the frequency to be modulated by the audio
signal. The value of this resistor is calculated for several
Q factor ranges of the coil for a sound frequency of
5.5 MHz (see Table 7).
Fig.10 Typical modulation depth as a function of
the value of R17.
handbook, halfpage
100
80
70
60
10 3
MBE398
102
10
90
R17 (k
)
modulation
depth
(%)
Table 7
Value of resistor for several Q factor ranges
The use of a coil with a quality factor <30 may result in a
non operating oscillator. For safety, it is recommended to
use a coil with a quality factor
≥50.
Picture-to-sound ratio
The picture-to-sound ratio can be adjusted in the
application by changing the value of C17 (capacitor
between pin 17 and ground); see Fig.11.
Figure 11 shows us that the picture-to-sound ratio will
change for a constant value of C17 when the sound
subcarrier frequency will change.
RF harmonics
This IC has been designed to have the lowest level of
unwanted RF harmonics at the frequencies where these
are the hardest to be filtered out, especially for the second
harmonic of the RF carrier at the lowest frequencies of the
UHF band.
The level of the second and third RF harmonic is shown in
Fig.12 for an asymmetrical application. This chart gives a
typical value while the level of these harmonics can vary
depending on the design of the application.
It is possible to reduce the level of the second harmonic by
using a wide band transformer at the output of the IC and
create a symmetrical application (see Fig.9).
To reduce the out-of-band harmonics and especially the
third one, it is necessary to use a low-pass filter at the
output of the IC.
COIL QUALITY
FACTOR
PROPOSED VALUE FOR R3
(k
)
30 to 40
82 to 33
40 to 50
33 to 27
50 to 60
27 to 22
60 to 80
22 to 18
80 to >100
18 to 15
相關PDF資料
PDF描述
TDA8741H-T FM, AUDIO DEMODULATOR, PQFP44
TDA8742 FM, AUDIO DEMODULATOR, PDIP42
TDA8742H-T FM, AUDIO DEMODULATOR, PQFP44
TDA8745N SPECIALTY CONSUMER CIRCUIT, PDIP42
TDA8752H/8-T 3-CH 8-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQFP100
相關代理商/技術參數
參數描述
TDA8722T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:I2C-bus programmable modulator for negative video modulation and FM sound
TDA8725T 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Antenna signal processor
TDA8730 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:PLL FM demodulator for DBS signals
TDA8732 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:NICAM-728 demodulator NIDEM
TDA8735 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:PLL frequency synthesizer
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*