參數資料
型號: TDA7407TR
廠商: STMICROELECTRONICS
元件分類: 消費家電
英文描述: SPECIALTY CONSUMER CIRCUIT, PQFP44
封裝: 10 X 10 MM, 1.40 MM HEIGHT, LQFP-44
文件頁數: 26/46頁
文件大?。?/td> 692K
代理商: TDA7407TR
Obsolete
- Obsolete
Product(s)
Multipath detector
TDA7407
Figure 24.
Block diagram of the multipath detector
5.4.1
Programming
To obtain a good multipath performance an adaptation is necessary. Therefore the gain of
the 19kHz bandpass is programmable in four steps as well as the rectifier gain. The attack
and decay times can be set by the external capacitor value.
5.4.2
Quality detector
The TDA7407 offers a quality detector output which gives a voltage representing the FM
reception conditions. To calculate this voltage the MPX noise and the multipath detector
output are summed according to the following formula:
Quality = 1.6 (Vnoise -0.8V)+ a (REF5V - VMPOUT)
The noise signal is the PEAK signal without additional influences. The factor "a" can be
programmed from 0.7 to 1.15. the output is a low impedance output able to drive external
circuitry as well as simply fed to an A/D converter for RDS applications.
5.4.3
AF Search Control
The TDA7407 is supplied with several functionality to support AF checks using the stereo
decoder. As mentioned already before the high ohmic mute feature avoids any clicks during
the jump condition. It is possible at the same time, to evaluate the noise and multipath
content of the alternate frequency, by using the quality detector output. Therefore the
multipath detector is switched automatically to a small time constant. No additional pin
(AFS) is implemented in order to separate the audioprocessor mute and stereo decoder AF
functions. In Figure 25 the block diagram and control functions of the complete AFS
functionality is shown (please note that the pins AFS and SM are active low as well as all
control bits indicated by an overbar).
5.5
Test mode
During the test mode, which can be activated by setting bit D0 of the testing byte and bit D5
of the subaddress byte to "1", several internal signals are available at the CASSR pin.
During this mode the input resistor of 100kOhm is disconnected from the pin. The internal
signals available are shown in the software specification.
相關PDF資料
PDF描述
TDA7407 SPECIALTY CONSUMER CIRCUIT, PQFP44
TDA7409D 1 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7410NDTR 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7410ND 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7410 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
相關代理商/技術參數
參數描述
TDA7409 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:CARRADIO-SIGNAL-PROCESSOR
TDA7409D 功能描述:音頻 DSP INFOTAINMENT SIGNAL RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7409DTR 功能描述:音頻 DSP INFOTAINMENT SIGNAL RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7410D 制造商:STMicroelectronics 功能描述:
TDA7410ND 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Signal processor for car radio applications