- 您現在的位置：買賣IC網 > PDF目錄98195 > TDA7407TR (STMICROELECTRONICS) SPECIALTY CONSUMER CIRCUIT, PQFP44 PDF資料下載
參數資料
| 型號： | TDA7407TR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP44 |
| 封裝： | 10 X 10 MM, 1.40 MM HEIGHT, LQFP-44 |
| 文件頁數： | 24/46頁 |
| 文件大小： | 692K |
| 代理商： | TDA7407TR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
Obsolete
Product(s)
- Obsolete
Product(s)
Multipath detector
TDA7407
The block diagram of the noiseblanker is given in Figure 23.
In the first stage the spikes must be detected but to avoid wrong triggering on high
frequency (white) noise, a complex trigger control is implemented. Behind the trigger stage
a pulse former generates the "blanking" pulse. To avoid any crosstalk to the signal path the
noiseblanker is supplied by his own biasing circuit.
5.2.11
Trigger path
The incoming MPX signal is highpass filtered, amplified and rectified. This second order
highpass filter has a corner frequency of 140kHz.
The rectified signal, RECT, is lowpass filtered to generate a signal called PEAK. Also noise
with a frequency 140kHz increases the PEAK voltage. The resulting voltage can be adjusted
by use of the noise rectifier discharge current.
The PEAK voltage is fed to a threshold generator, which adds to the PEAK voltage a DC
dependent threshold VTH. Both signals, RECT and PEAK+VTH are fed to a comparator
which triggers a re-triggerable monoflop. The monoflop's output activates the sample and
hold circuits in the signal path for selected duration.
Figure 23.
Block Diagram of the Noiseblanker
5.2.12
Automatic noise controlled threshold adjustment (ATC)
There are mainly two independent possibilities for programming the trigger threshold:
a)
the low threshold in 8 steps (bits D0 to D2 of the noiseblanker byte)
b)
the noise adjusted threshold in 4 steps (bits D3 and D4 of the noiseblanker byte,
see Figure 23).
The low threshold is active in combination with a good MPX signal without any noise; the
PEAK voltage is less than 1V. The sensitivity in this operation is high.
If the MPX signal is noisy the PEAK voltage increases due to the higher noise, which is also
rectified. With increasing of the PEAK voltage the trigger threshold increases, too. This
particular gain is programmable in 4 steps.
+
-
RECTIFIER
LOWPASS
RECT
+
THRESHOLD
GENERATOR
VTH
PEAK
ADDITIONAL
THRESHOLD
CONTROL
MONOFLOP
HOLDN
MPX
D98AU856
MPX
CONTROL
相關PDF資料 |
PDF描述 |
|---|---|
| TDA7407 | SPECIALTY CONSUMER CIRCUIT, PQFP44 |
| TDA7409D | 1 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20 |
| TDA7410NDTR | 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20 |
| TDA7410ND | 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20 |
| TDA7410 | 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TDA7409 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:CARRADIO-SIGNAL-PROCESSOR |
| TDA7409D | 功能描述:音頻 DSP INFOTAINMENT SIGNAL RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7409DTR | 功能描述:音頻 DSP INFOTAINMENT SIGNAL RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube |
| TDA7410D | 制造商:STMicroelectronics 功能描述: |
| TDA7410ND | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Signal processor for car radio applications |
發布緊急采購，3分鐘左右您將得到回復。