參數資料
型號： TDA7405
廠商： STMICROELECTRONICS
元件分類： 音頻控制
英文描述： 2 CHANNEL(S), TONE CONTROL CIRCUIT, PQFP44
封裝： 10 X 10 MM, 1.40 MM HEIGHT, TQFP-44
文件頁數： 13/57頁
文件大?。?/td> 750K
代理商： TDA7405
Obsolete
Product(s)
- Obsolete
Product(s)
TDA7405
20/57
5.10 Compander
5.10.1Signal-Compression
A fully integrated signal-compressor with programmable Attack- and Decay-times is present in the A631 (see
Figure 20). The compander consists of a signal-level detection, an A/D-Converter plus adder and the normal
SoftStep-Volume-stage. First of all the left and the right InGain-signal is rectified, respectively, and the logarithm
is build from the summed signal. The following low-pass smooth the output-signal of the logarithm-amplifier and
improves the low-frequency suppression. The low-pass output-voltage then is A/D-converted an added to the
current volume-word defined by the IIC-Bus. Assuming reference-level or higher at the compander input, the
output of the ADC is 0. At lower levels the voltage is increasing with 1 Bit/dB. It is obvious that with this config-
uration and a 0.5dB-step volume-stage the compression rate is fixed to 2:1 (1dB less at the input leads to 0.5dB
less at the output). The internal reference-level of the compander is programmable in three steps from 0.5VRMS
to 2VRMS. For a proper behavior of the compression-circuit it is mandatory to have at a 0dB input-signal exactly
the programmed reference-level after the InGain-stage. E.g. at a configured reference-level of 0.5VRMS the out-
put of the InGain-stage has to have also 0.5VRMS at 0dB source-signal (Usually the 0dB for CD is defined as
the maximum possible signal-level). To adapt the external level to the internal reference-level the programmable
attenuation in the differential-stages and the InGain can be used.
Figure 21. Compander Block Diagram
5.10.2Anti-Clipping
In a second application the compander-circuit can be used for a Anti-Clipping or Limiting function. In this case one of
the dedicated inputs (AM or MPin) is connected directly to the Clip-Detector of the Power-Amplifier. If no clipping is
detected, the open-collector output of the Power-Amplifier is highohmic and the input-voltage of the rectifier is VREF.
The level-detector interprets this as a very small signal and reacts with the maximum programmed compander-gain.
In the application this gain has to be compensated by decreasing the volume with the same value in order to get the
desired output-level. In clipping situation the open-collector-current generates a voltage-drop at the rectifier-input,
which forces the compander to decrease the gain until the clipping disappears.
It is even possible to run the compression-mode and the Anti-Clipping mode in parallel. In this case the maxi-
mum compander-Gain should be set to 29 dB.
相關PDF資料
PDF描述
TDA7406T SPECIALTY CONSUMER CIRCUIT, PQFP44
TDA7407TR SPECIALTY CONSUMER CIRCUIT, PQFP44
TDA7407 SPECIALTY CONSUMER CIRCUIT, PQFP44
TDA7409D 1 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
TDA7410NDTR 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO20
相關代理商/技術參數
參數描述
TDA7405_04 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:EQUALIZER CARRADIO SIGNAL PROCESSOR
TDA7405TR 功能描述:處理器 - 專門應用 EQUALIZER CAR RADIO SIGNAL PROCESSOR RoHS:否 制造商:Freescale Semiconductor 類型:Multimedia Applications 核心:ARM Cortex A9 處理器系列:i.MX6 數據總線寬度:32 bit 最大時鐘頻率:1 GHz 指令/數據緩存: 數據 RAM 大小:128 KB 數據 ROM 大小: 工作電源電壓: 最大工作溫度:+ 95 C 安裝風格:SMD/SMT 封裝 / 箱體:MAPBGA-432
TDA7406 功能描述:音頻 DSP Car Radio Signal RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
TDA7406T 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:CAR RADIO SIGNAL PROCESSOR
TDA7406TR 功能描述:音頻 DSP INFOTAINMENT SIGNAL RoHS:否 制造商:Texas Instruments 工作電源電壓: 電源電流: 工作溫度范圍: 安裝風格: 封裝 / 箱體: 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*