- 您現在的位置：買賣IC網 > PDF目錄9816 > TC7109IJL (Microchip Technology)IC ADC 12BIT HANDSHAKE 40CDIP PDF資料下載
參數資料
| 型號： | TC7109IJL |
| 廠商： | Microchip Technology |
| 文件頁數： | 9/30頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT HANDSHAKE 40CDIP |
| 標準包裝： | 10 |
| 位數： | 12 |
| 數據接口： | 串行，并聯 |
| 轉換器數目： | 1 |
| 電壓電源： | 雙 ± |
| 工作溫度： | -25°C ~ 85°C |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 40-CDIP（0.600"，15.24mm） |
| 供應商設備封裝： | 40-Cerdip |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
2006 Microchip Technology Inc.
DS21456C-page 17
TC7109/A
4.0
INTERFACING
4.1
Direct Mode
Combinations of chip enable and byte enable control
signals, which may be used when interfacing the
TC7109A to parallel data lines, are shown in Figure .
The CE/LOAD input may be tied low, allowing either byte
to be controlled by its own enable (see Figure (A)).
Figure (B) shows the HBEN and LBEN as flag inputs,
and CE/LOAD as a master enable, which could be the
READ strobe available from most microprocessors.
Figure (C) shows a configuration where the two byte
enables are connected together. The CE/LOAD is a
chip enable, and the HBEN and LBEN may be used as
a second chip enable, or connected to ground. The 14
data outputs will be enabled at the same time. In the
direct MODE, SEND should be tied to V+.
Figure shows interfacing several TC7109A’s to a bus,
ganging the HBEN and LBEN signals to several
converters together, and using the CE/LOAD input to
select the desired converter.
the parallel three-state output capabilities of the
TC7109A. Figure shows parallel interface to the 8748/
49 systems via an 8255 PPI, where the TC7109A data
outputs are active at all times. This interface can be
used in a read-after-update sequence, as shown in
Figure . The data is accessed by the high-to-low
transition of the Status driving an interrupt to the
microcontroller.
The RUN/HOLD
input is
also used to initiate
conversions under software control.
Direct interfacing to most microcontroller busses is
easily accomplished through the three-state output of
the TC7109A.
Figure 4-8 is a typical connection diagram. To ensure
requirements for setup and hold times, minimum pulse
widths, and the drive limitations on long busses are
met, it is necessary to carefully consider the system
timing in this type of interface. This type of interface is
used when the memory peripheral address density is
low, providing simple address decoding. Interrupt
handling can be simplified by using an interface to
reduce the component count.
FIGURE 4-1:
Direct Mode Chip and Byte Enable Combination
TC7109A
MODE
CE/LOAD
B9 - B12
POL, OR
B1 - B8
LBEN
HBEN
GND
8
Analog In
6
Convert
Control
RUN/HOLD
TC7109A
MODE
CE/LOAD
B1 - B12
POL, OR
LBEN
HBEN
GND
Analog In
Convert
RUN/HOLD
TC7109A
MODE
CE/LOAD
B9 - B12
POL, OR
B1 - B8
LBEN
HBEN
8
Analog In
6
Convert
RUN/HOLD
Chip Select 1
GND or
Chip Select 2
14
Byte Flags
GND
Chip Select
A.B.
C.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3186EAP+T | IC RS-232 SERIAL 230KBPS 20-SSOP |
| MAX3186EWP+T | IC RS-232 SERIAL 230KBPS 20-SOIC |
| MS27505E11B98PB | CONN RCPT 6POS BOX MNT W/PINS |
| VE-B52-MW-F1 | CONVERTER MOD DC/DC 15V 100W |
| MS27496E9B35S | CONN RCPT 6POS BOX MNT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TC7-10-C100 | 功能描述:電纜固定件和配件 CBL STRAP W/ TACK NAIL RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度: |
| TC7110A | 制造商:Thomas & Betts 功能描述:Fittings Connector 4inch Steel |
| TC7110A-RT | 制造商:Thomas & Betts 功能描述:4 IN INSL RAINTIGTH COMP FITTING |
| TC7110US | 制造商:Thomas & Betts 功能描述:SG TC7110US 4 IN INS EMT COMPRESSIO |
| TC7116 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:3-1/2 Digit Analog-to-Digital Converters with Hold |
發布緊急采購，3分鐘左右您將得到回復。