- 您現在的位置：買賣IC網 > PDF目錄98167 > TB6549F BRUSH DC MOTOR CONTROLLER, 3.5 A, PDSO20 PDF資料下載
參數資料
| 型號： | TB6549F |
| 元件分類： | 運動控制電子 |
| 英文描述： | BRUSH DC MOTOR CONTROLLER, 3.5 A, PDSO20 |
| 封裝： | 0.450 INCH, 1 MM PITCH, PLASTIC, HSOP-20/22 |
| 文件頁數： | 19/22頁 |
| 文件大?。?/td> | 398K |
| 代理商： | TB6549F |
TB6549F/FG/P/PG/HQ
2006-11-07
6
Component Description
1.
Control Input/PWM Input Circuit
The input signals are shown below. Input at the CMOS and TTL levels can be provided. Note that the
input signals have a hysteresis of 0.2 V (typ.).
VINH: 2 to Vreg V
VINL: GND to 0.8 V
The PWM input frequency should be 100 kHz or less.
Input/Output Function
Input
Output
IN1
IN2
SB
PWM
OUT1
OUT2
Mode
H
L
Short brake
H
L
H
CW/CCW
L
H
L
Short brake
H
L
CCW/CW
H
L
H
L
Short brake
H
L
H
L
OFF
(high impedance)
Stop
H
H/L
L
OFF
(high impedance)
Standby
PWM control function
Motor speed can be controlled by inputting the 0/5-V PWM signal to the PWM pin.
When PWM control is provided, normal operation and short brake operation are repeated.
If the upper and lower power transistors in the output circuit were ON at the same time, a penetrating
current would be produced. To prevent this current from being produced, a dead time of 300 ns (design
target value) is provided in the IC when either of the transistors changes from ON to OFF, or vice versa.
Therefore, PWM control by synchronous rectification is enabled without an OFF time being inserted by
external input. Note that a dead time is also provided in the IC at the time of transition between CW
and CCW or between CW (CCW) and short brake mode, thereby eliminating the need for an OFF time.
VDD
100 k
IN1
(IN2, PWM)
相關PDF資料 |
PDF描述 |
|---|---|
| TB6549HQ | BRUSH DC MOTOR CONTROLLER, 5 A, ZIP25 |
| TB6551FAG | BRUSHLESS DC MOTOR CONTROLLER, PDSO24 |
| TB6552FL | BRUSH DC MOTOR CONTROLLER, 1 A, PQCC24 |
| TB6552FN | BRUSH DC MOTOR CONTROLLER, 1 A, PDSO16 |
| TB6559FG | BRUSH DC MOTOR CONTROLLER, 2.5 A, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TB6549F_07 | 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Full-Bridge Driver IC for DC Motors |
| TB6549FG | 制造商:Toshiba 功能描述:Full Bridge Motor Driver 22-Pin (20+2Tab) HSOP Bulk 制造商:Toshiba America Electronic Components 功能描述:DRIVER FULL BRIDGE SMD HSOP20 制造商:Toshiba America Electronic Components 功能描述:DRIVER, FULL BRIDGE, SMD, HSOP20 |
| TB6549FG(EL) | 功能描述:馬達/運動/點火控制器和驅動器 Bridge Driver RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| TB6549FG(O) | 制造商:Toshiba America Electronic Components 功能描述:Moter Driver,Full Brdg Driver,HSOP20 |
| TB6549FG(O,EL) | 功能描述:馬達/運動/點火控制器和驅動器 Bridge Driver 30V 3.5A 4 modes RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。