- 您現在的位置：買賣IC網 > PDF目錄385896 > TA3020 (Electronic Theatre Controls, Inc.) Stereo 300W (4з) Class-T Digital Audio Amplifier Driver using Digital Power ProcessingTM Technology PDF資料下載
參數資料
| 型號： | TA3020 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | 運動控制電子 |
| 英文描述： | Stereo 300W (4з) Class-T Digital Audio Amplifier Driver using Digital Power ProcessingTM Technology |
| 中文描述： | 立體聲300W的（4з）類- T數字音頻放大器驅動器使用數字電源ProcessingTM技術 |
| 文件頁數： | 8/29頁 |
| 文件大?。?/td> | 284K |
| 代理商： | TA3020 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
T E C H N I C A L I N F O R M A T I O N
8
TA3020, Rev 2.1, 01.01
External Components Description
(Refer to the Application/Test Circuit)
Components Description
R
I
Inverting input resistance to provide AC gain in conjunction with R
F
. This input is
biased at the BIASCAP voltage (approximately 2.5VDC).
R
F
Feedback resistor to set AC gain in conjunction with R
I
. Please refer to the Amplifier
Gain paragraph, in the Application Information section.
C
I
AC input coupling capacitor which, in conjunction with R
I
, forms a highpass filter at
)
C
R
2
(
1
f
I
I
C
π
=
.
R
FBA
Feedback divider resistor connected to V5. This resistor is normally set at 1k
.
R
FBB
Feedback divider resistor connected to AGND. This value of this resistor depends
on the supply voltage setting and helps set the TA3020 gain in conjunction with R
I,
R
F,
R
FBA,
and R
FBC
. Please see the Modulator Feedback Design paragraphs in the
Application Information Section.
R
FBC
Feedback resistor connected from either the OUT1(OUT2) to FBKOUT1(FBKOUT2)
or speaker ground to FBKGND1(FBKGND2). The value of this resistor depends on
the supply voltage setting and helps set the TA3020 gain in conjunction with R
I,
R
F,
R
FBA,
, and R
FBB
. It should be noted that the resistor from OUT1(OUT2) to
FBKOUT1(FBKOUT2) must have a power rating of greater than
Please see the Modulator Feedback Design paragraphs in the Application
Information Section.
C
FB
Feedback delay capacitor that both lowers the idle switching frequency and filters
very high frequency noise from the feedback signal, which improves amplifier
performance. The value of C
FB
should be offset between channel 1 and channel 2
so that the idle switching difference is greater than 40kHz. Please refer to the
Application / Test Circuit.
R
OFA
Potentiometer used to manually trim the DC offset on the output of the TA3020.
R
OFB
Resistor that limits the manual DC offset trim range and allows for more precise
adjustment.
R
REF
Bias resistor. Locate close to pin 32 and ground at pin 28.
C
A
BIASCAP decoupling capacitor. Should be located close to pin 19 and grounded at
pin 28.
D
B
Bootstrap diode. This diode charges up the bootstrap capacitors when the output is
low (at VNN) to drive the high side gate circuitry. A fast or ultra fast recovery diode
is recommended for the bootstrap circuitry. In addition, the bootstrap diode must be
able to sustain the entire VPP-VNN voltage. Thus, for most applications, a 150V (or
greater) diode should be used.
C
B
High frequency bootstrap capacitor, which filters the high side gate drive supply.
This capacitor must be located as close to pin 40 (VBOOT1) or pin10 (VBOOT2) for
reliable operation. The “negative” side of C
B
should be connected directly to the
HO1COM (pin 46) or HO2COM (pin 4). Please refer to the Application / Test Circuit.
C
BAUX
Bulk bootstrap capacitor that supplements C
B
during “clipping” events, which result
in a reduction in the average switching frequency.
R
B
Bootstrap resistor that limits C
BAUX
charging current during TA3020 power up
(bootstrap supply charging).
C
SW
VN10 generator filter capacitors. The high frequency capacitor (0.1uF) must be
located close to pin 1 (VN10) to maximize device performance.
C
S
Supply decoupling for the power supply pins. For optimum performance, these
components should be located close to the TA3020 and returned to their respective
)
(2R
VPP
P
FBC
2
DISS
=
.
相關PDF資料 |
PDF描述 |
|---|---|
| TA31273FN | AM RF/IF Detector IC |
| TA32305 | RF 1chip Receiver and Transmitter for low power wireless |
| TA32305FN | RF 1chip Receiver and Transmitter for low power wireless |
| TA32305FNG | RF 1chip Receiver and Transmitter for low power wireless |
| TA4107F | Bipolar Linear Integrated Circuit Silicon Monolithic |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TA3025PA4K50FE | 制造商:OHMITE 制造商全稱:Ohmite Mfg. Co. 功能描述:Power Chip Thick Film on Alumina Substrate |
| TA3025PA4K50JE | 制造商:OHMITE 制造商全稱:Ohmite Mfg. Co. 功能描述:Power Chip Thick Film on Alumina Substrate |
| TA3025PA4K50KE | 制造商:OHMITE 制造商全稱:Ohmite Mfg. Co. 功能描述:Power Chip Thick Film on Alumina Substrate |
| TA303 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Chip Resistors Thick Film on Alumina Substrate |
| TA303PA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Chip Resistors Thick Film on Alumina Substrate |
發布緊急采購，3分鐘左右您將得到回復。