參數資料
型號: TA2069AF
元件分類: 音頻控制
英文描述: 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO24
封裝: 0.300 INCH, 1 MM PITCH, PLASTIC, SSOP-24
文件頁數: 5/14頁
文件大小: 298K
代理商: TA2069AF
TDA9885_TDA9886_3
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 03 — 16 December 2008
13 of 56
NXP Semiconductors
TDA9885; TDA9886
I2C-bus controlled multistandard alignment-free IF-PLL demodulators
The AF preamplier used for FM sound is an operational amplier with internal feedback,
high gain and high common mode rejection. The AF voltage from the PLL demodulator is
5 mV (RMS) for a frequency deviation of 27 kHz and is amplied by 30 dB. By the use of a
DC operating point control circuit (with external capacitor CAF), the AF preamplier is
decoupled from the PLL DC voltage. The low-pass characteristic of the amplier reduces
the harmonics of the 2nd SIF signal at the AF output terminal.
For FM sound a switchable de-emphasis network (with external capacitor) is implemented
between the preamplier and the output amplier.
The AF output amplier provides the required AF output level by a rail-to-rail output stage.
A preceding stage makes use of an input selector for switching between FM sound,
AM sound and mute state. The gain can be switched between 10 dB (normal) and 4 dB
(reduced).
Switching to the mute state is controlled automatically, dependent on the digital
acquisition help in case the VCO of the FM PLL is not in the required frequency window.
This is done by a time constant: fast for switching to the mute state and slow (typically
40 ms) for switching to the no-mute state.
All switching functions are controlled via the I2C-bus:
AM sound, FM sound and forced mute
Auto mute enable or disable
De-emphasis off or on with 50
sor75 s
Audio gain normal or reduced
8.15 Internal voltage stabilizer
The band gap circuit internally generates a voltage of approximately 2.4 V, independent of
supply voltage and temperature. A voltage regulator circuit, connected to this voltage,
produces a constant voltage of 3.55 V which is used as an internal reference voltage.
8.16 I2C-bus transceiver and MAD
The device can be controlled via the 2-wire I2C-bus by a microcontroller. Two wires carry
serial data (SDA) and serial clock (SCL) information between the devices connected to
the I2C-bus.
The device has an I2C-bus slave transceiver with auto-increment. The circuit operates up
to clock frequencies of 400 kHz.
A slave address is sent from the master to the slave receiver. To avoid conicts in a real
application with other devices providing similar or complementing functions, there are four
possible slave addresses available. These MADs can be selected by connecting resistors
on pin SIOMAD and/or pins SIF1 and SIF2 (see Figure 26). Pin SIOMAD relates with
bit A0 and pins SIF1 and SIF2 relate with bit A3. The slave addresses of this device are
given in Table 4.
The power-on preset value is dependent on the use of pin SIOMAD and can be chosen for
45.75 MHz NTSC as default (pin SIOMAD left open-circuit) or 58.75 MHz NTSC (resistor
on pin SIOMAD). In this way the device can be used without the I2C-bus as an NTSC only
device.
相關PDF資料
PDF描述
TA2104BFN AUDIO TUNER, PDSO24
TA2104BN AUDIO TUNER, PDIP24
TA2111FG AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO24
TA2111FNG AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO24
TA2111NG AM/FM, AUDIO SINGLE CHIP RECEIVER, PDIP24
相關代理商/技術參數
參數描述
TA207 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Chip Resistors Thick Film on Alumina Substrate
TA2078P 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:PRESET EQUALIZER IC
TA2078P_02 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Bipolar Linear Integrated Circuit Silicon Monolithic Preset Equalizer IC
TA207PA 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Chip Resistors Thick Film on Alumina Substrate
TA207PA100KJ 制造商:Ohmite Mfg Co 功能描述:Res Thick Film 100K Ohm 5% 7.5W ±50ppm/°C Molded RDL Thru-Hole