參數資料
型號: TA2069AF
元件分類: 音頻控制
英文描述: 2 CHANNEL(S), TONE CONTROL CIRCUIT, PDSO24
封裝: 0.300 INCH, 1 MM PITCH, PLASTIC, SSOP-24
文件頁數: 14/14頁
文件大小: 298K
代理商: TA2069AF
TDA9885_TDA9886_3
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 03 — 16 December 2008
9 of 56
NXP Semiconductors
TDA9885; TDA9886
I2C-bus controlled multistandard alignment-free IF-PLL demodulators
8.3 VIF-AGC detector
Gain control is performed by sync level detection (negative modulation) or peak white
detection (positive modulation).
For negative modulation, the sync level voltage is stored at an integrated capacitor by
means of a fast peak detector. This voltage is compared with a reference voltage (nominal
sync level) by a comparator which charges or discharges the integrated AGC capacitor for
providing of the required VIF gain. The time constants for decreasing or increasing the
gain are nearly equal and the total AGC reaction time is fast to cope with ‘aeroplane
uttering’.
For positive modulation, the white peak level voltage is compared with a reference voltage
(nominal white level) by a comparator which charges (fast) or discharges (slow) the
external AGC capacitor directly for providing the required VIF gain. The need of a very
long time constant for VIF gain increase is due to peak white level may appear only once
in a eld. In order to reduce this time constant, an additional level detector increases the
discharging current of the AGC capacitor (fast mode) in the event of a decreasing VIF
amplitude step controlled by the detected actual black level voltage. The threshold level for
fast mode AGC is typically
6 dB video amplitude. The fast mode state is also transferred
to the SIF-AGC detector for speed-up. In case of missing peak white pulses, the VIF gain
increase is limited to typically +3 dB by comparing the detected actual black level voltage
with a corresponding reference voltage.
8.4 FPLL detector
The VIF amplier output signal is fed into a frequency detector and into a phase detector
via a limiting amplier for removing the video AM.
During acquisition the frequency detector produces a current proportional to the
frequency difference between the VIF and the VCO signals. After frequency lock-in the
phase detector produces a current proportional to the phase difference between the VIF
and the VCO signals. The currents from the frequency and phase detectors are charged
into the loop lter which controls the VIF VCO and locks it to the frequency and phase of
the VIF carrier.
For a positive modulated VIF signal, the charging currents are optional gated by the
composite sync in order to avoid signal distortion in case of overmodulation. The gating
depth is switchable via the I2C-bus.
8.5 VCO and divider
The VCO of the VIF FPLL operates as an integrated low radiation relaxation oscillator at
double the picture carrier frequency. The control voltage, required to tune the VCO to
double the picture carrier frequency, is generated at the loop lter by the frequency phase
detector. The possible frequency range is 50 MHz to 140 MHz (typical value).
The oscillator frequency is divided-by-two to provide two differential square wave signals
with exactly 90 degrees phase difference, independent of the frequency, for use in the
FPLL detectors, the video demodulator and the intercarrier mixer.
相關PDF資料
PDF描述
TA2104BFN AUDIO TUNER, PDSO24
TA2104BN AUDIO TUNER, PDIP24
TA2111FG AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO24
TA2111FNG AM/FM, AUDIO SINGLE CHIP RECEIVER, PDSO24
TA2111NG AM/FM, AUDIO SINGLE CHIP RECEIVER, PDIP24
相關代理商/技術參數
參數描述
TA207 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Chip Resistors Thick Film on Alumina Substrate
TA2078P 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:PRESET EQUALIZER IC
TA2078P_02 制造商:TOSHIBA 制造商全稱:Toshiba Semiconductor 功能描述:Bipolar Linear Integrated Circuit Silicon Monolithic Preset Equalizer IC
TA207PA 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Chip Resistors Thick Film on Alumina Substrate
TA207PA100KJ 制造商:Ohmite Mfg Co 功能描述:Res Thick Film 100K Ohm 5% 7.5W ±50ppm/°C Molded RDL Thru-Hole