參數資料
型號： T431616E-7S
廠商： TM Technology, Inc.
英文描述： 1M x 16 SDRAM 512K x 16bit x 2Banks Synchronous DRAM
中文描述： 100萬× 16內存為512k × 16Bit的X 2Banks同步DRAM
文件頁數： 6/74頁
文件大小： 781K
代理商： T431616E-7S
TE
CH
tm
Commands
T431616D/E
TM Technology Inc. reserves the right
P. 6
to change products or specifications without notice.
Publication Date: FEB. 2007
Revision: A
1
BankPrecharge command
(RAS# = "L", CAS# = "H", WE# = "L", A11 = “V”, A10 = "L", A0-A9 = Don't care)
The BankPrecharge command precharges the bank disignated by A11 signal. The precharged bank is
switched from the active state to the idle state. This command can be asserted anytime after t
RAS
(min.) is satisfied
from the BankActivate command in the desired bank. The maximum time any bank can be active is specified by
t
RAS
(max.). Therefore, the precharge function must be performed in any active bank within t
RAS
(max.). At the
end of precharge, the precharged bank is still in the idle state and is ready to be activated again.
2
PrechargeAll command
(RAS# = "L", CAS# = "H", WE# = "L", A11 = Don't care, A10 = "H", A0-A9 = Don't care)
The PrechargeAll command precharges both banks simultaneously and can be issued even if both banks are
not in the active state. Both banks are then switched to the idle state.
3
Read command
(RAS# = "H", CAS# = "L", WE# = "H", A11= “V”, A9 = "L", A0-A7 = Column Address)
The Read command is used to read a burst of data on consecutive clock cycles from an active row in an
active bank. The bank must be active for at least t
RCD
(min.) before the Read command is issued. During read
bursts, the valid data-out element from the starting column address will be available following the CAS# latency
after the issue of the Read command. Each subsequent data-out element will be valid by the next positive clock
edge (refer to the following figure). The DQs go into high-impedance at the end of the burst unless other
command is initiated. The burst length, burst sequence, and CAS# latency are determined by the mode register,
which is already programmed. A full-page burst will continue until terminated (at the end of the page it will wrap
to column 0 and continue).
CLK
COMMAND
CAS# latency=1
tCK1, DQ's
CAS# latency=2
tCK2, DQ's
CAS# latency=3
tCK3, DQ's
T0
T 1
T2
T3
T4
T5
T6
T7
T8
READ A
NOP
NOP
NOP
NOP
NOP
NOP
NOP
NOP
DOUT A0
DOUT A1
DOUT A2
DOUT A3
DOUT A0
DOUT A1
DOUT A2
DOUT A3
DOUT A0
DOUT A1
DOUT A2
DOUT A3
Burst Read Operation
(Burst Length = 4, CAS# Latency = 1, 2, 3)
相關PDF資料
PDF描述
T431616E-7SG 1M x 16 SDRAM 512K x 16bit x 2Banks Synchronous DRAM
T436416A 4M X 16 SDRAM
T436416A-10S 4M X 16 SDRAM
T436416A-10SG Terminal Block End Barrier; For Use With:AB1 Series Terminal Blocks; Accessory Type:End Barrier; Leaded Process Compatible:Yes; Peak Reflow Compatible (260 C):Yes RoHS Compliant: Yes
T436416A-6S 4M X 16 SDRAM
相關代理商/技術參數
參數描述
T431616E-7SG 制造商:TMT 制造商全稱:TMT 功能描述:1M x 16 SDRAM 512K x 16bit x 2Banks Synchronous DRAM
T4322 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIANGULAR TYPE
T4323 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIANGULAR TYPE
T4333 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIANGULAR TYPE
T43331G 制造商:BITECH 制造商全稱:Bi technologies 功能描述:Thick Film Super Low Profile SIP Resistor Networks
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*