參數資料
型號: SY87702LHI
廠商: Micrel Inc
文件頁數: 10/14頁
文件大?。?/td> 0K
描述: IC CLOCK/DATA RECOVERY 64-TQFP
標準包裝: 160
系列: AnyRate®
類型: 時鐘和數據恢復(CDR),多路復用器
PLL:
主要目的: 以太網,SONET/SDH,ATM 應用
輸入: PECL
輸出: CML,PECL
電路數: 1
比率 - 輸入:輸出: 1:6
差分 - 輸入:輸出: 是/是
頻率 - 最大: 2.5Gbps
電源電壓: 3.15 V ~ 3.45 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 64-TQFP 裸露焊盤
供應商設備封裝: 64-EP-TQFP
包裝: 托盤
SY87702L
5
Micrel, Inc.
M9999-072706
hbwhelp@micrel.com or (408) 955-1690
FUNCTIONAL DESCRIPTION
Clock Recovery
Clock Recovery, as shown in the block diagram,
generates a clock that is at the same frequency as the
incoming data bit rate at the Serial Data input. The clock is
phase aligned by a PLL so that it samples the data in the
center of the data eye pattern.
The phase relationship between the edge transitions of
the data and those of the generated clock are compared by
a phase/frequency detector. Output pulses from the detector
indicate the required direction of phase correction. These
pulses are smoothed by an integral loop filter. The output of
the loop filter controls the frequency of the Voltage Controlled
Oscillator (VCO), which generates the recovered clock.
Frequency stability, without incoming data, is guaranteed
by an alternate reference input (REFCLK) that the PLL locks
onto when data is lost. If the Frequency of the incoming
signal varies by greater than approximately 1000ppm with
respect to the synthesizer frequency, the PLL will be declared
out of lock, and the PLL will lock to the multiplied frequency
of the reference clock.
The loop filter transfer function is optimized to enable the
PLL to track the jitter, yet tolerate the minimum transition
density expected in a received SONET data signal. This
transfer function yields a 30s data stream of continuous
1's or 0's for random incoming NRZ data.
The total loop dynamics of the clock recovery PLL
provides jitter tolerance which is better than the specified
tolerance in GR-253-CORE.
PIN NAMES
INPUTS
RDIN
± [Serial Data Input] – Differential PECL
This differential input accepts the receive serial data
stream. An internal receive PLL recovers the embedded
clock (RCLK) and data (RDOUT) information. The incoming
data rate can be within one of ten frequency ranges, or can
be one of five specific frequencies, depending on the state
of the FREQSEL and VCOSEL pins. The RDIN– pin has an
internal 75K resistor tied to VCC.
REFCLK
± [Reference Clock] – Differential PECL
This input is used as the reference for the internal
frequency synthesizer and the “training” frequency for the
receiver PLL to keep it centered in the absence of data
coming in on the RDIN input. The input frequency to
REFCLK is limited to 325MHz or less, depending on the
setting on the DIVSEL signals. The REFCLK– pin has an
internal 75K resistor tied to VCC.
CD [Carrier Detect] – PECL Input
This input controls the recovery function of the Receive
PLL and can be driven by the carrier detect output of optical
modules or from external transition detection circuitry. When
this input is HIGH, the input data stream (RDIN) is recovered
normally by the Receive PLL. When this input is LOW, the
data on the RDIN input will be internally forced to a constant
LOW, the data output RDOUT will remain LOW, the Link
Fault Indicator output LFIN forced LOW, and the clock
recovery PLL forced to lock onto the clock frequency
generated from REFCLK.
VCOSEL1, VCOSEL2 [VCO Select] – TTL Inputs
These inputs select the VCO frequency range via either
one of three wide-band PLLs, or a SONET/SDH specific
narrow-band PLL. Only the selected PLL is enabled. All
other PLL’s are disabled. Please refer to Table 1.
VCOSEL1
VCOSEL2
Choice
00
SONET/SDH
01
1.8 to 2.5GHz
10
1.25 to 1.8GHz
11
0.650 to 1.30GHz
Table. 1
相關PDF資料
PDF描述
SY87721LHI IC CLOCK/DATA RECOVERY 64-TQFP
SY87725LHY TR IC TRANSCEIVER SGL CHIP 64-TQFP
SY87729LHI IC SYNTHESIZER FRACT 3.3V 32TQFP
SY87739LHG IC SYNTHESIZER FRACT 3.3V 32TQFP
SY87813LHG IC CLOCK/DATA REC 1.3GBPS 32TQFP
相關代理商/技術參數
參數描述
SY87702LHITR 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V 28Mbps-2.5Gbps AnyRate CLOCK AND DATA RECOVERY
SY87721-EVAL 制造商:Micrel Inc 功能描述:
SY87721L 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:3.3V 28Mbps-2.7Gbps ANYRATE CLOCK AND DATA RECOVERY WITH INTEGRATED CLOCK MULTIPLIER UNIT
SY87721L_08 制造商:MICREL 制造商全稱:Micrel Semiconductor 功能描述:CLOCK AND DATA RECOVERY WITH INTEGRATED CLOCK MULTIPLIER UNIT
SY87721LHG 功能描述:IC CLOCK/DATA RECOVERY 64-TQFP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:AnyRate® 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT