- 您現在的位置：買賣IC網 > PDF目錄382555 > ST93CS66 (意法半導體) 4K (256 x 16) Serial Microwire EEPROM(4K位串行EEPROM) PDF資料下載
參數資料
| 型號： | ST93CS66 |
| 廠商： | 意法半導體 |
| 英文描述： | 4K (256 x 16) Serial Microwire EEPROM(4K位串行EEPROM) |
| 中文描述： | 4K的（256 × 16）系列微型導線的EEPROM（4K的位串行EEPROM的） |
| 文件頁數： | 6/16頁 |
| 文件大?。?/td> | 124K |
| 代理商： | ST93CS66 |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
POWER-ON DATA PROTECTION
In orderto prevent datacorruption and inadvertent
write operations during power up, a Power On
Reset(POR)circuit resetsallinternalprogramming
circuitry and sets the device in the Write Disable
mode. When V
CC
reaches its functionalvalue, the
deviceisproperlyreset (in the Write Disablemode)
and is ready to decode and execute an incoming
instruction. A stable V
CC
must be applied before
any logic signal.
INSTRUCTIONS
The ST93CS66/67 has eleven instructions, as
shown in Table 6. Each instructionis composedof
a 2 bitop-code andan 8bit address. Eachinstruc-
tion is preceded by the rising edge of the signal
appliedonthe Chip Select(S) input(assumingthat
the Clock C is low). The data input D is then
sampled upon the following rising edges of the
clock C until a ’1’ is sampled and decoded by the
ST93CS66/67as a Start bit.
The ST93CS66/67 is fabricated inCMOS technol-
ogyandisthereforeableto run from zeroHz (static
inputsignals)up to themaximumratings (specified
in Table 5).
Read
The Read instruction (READ) outputs serial data
on the Data Output (Q). Whena READinstruction
is received, the instruction and address are de-
codedand thedata from thememory is transferred
intoanoutputshiftregister.Adummy’0’bitisoutput
first followedby the 16 bitword with the MSBfirst.
Instruction
Description
W
pin
(1)
PRE
pin
Op
Code
Address
(1)
Data
Additional
Information
READ
Read Data from Memory
X
’0’
10
A7-A0
Q15-Q0
WRITE
Write Data to Memory
’1’
’0’
01
A7-A0
D15-D0
Write is executed if
the address is not
inside the
Protected area
PAWRITE
Page Write to Memory
’1’
’0’
11
A7-A0
D15-D0
Write is executed if
all the addresses
are not inside the
Protected area
WRALL
Write All Memory
’1’
’0’
00
01XX XXXX
D15-D0
Write all data ifthe
Protect Register is
cleared
WEN
Write Enable
’1’
’0’
00
11XX XXXX
WDS
Write Disable
X
’0’
00
00XX XXXX
PRREAD
Protect RegisterRead
X
’1’
10
XXXX XXXX
Q8-Q0
Data Output =
Protect Register
content + Protect
Flag bit
PRWRITE
Protect Register Write
’1’
’1’
01
A7-A0
Data above
specified address
A7-A0 are
protected
PRCLEAR
Protect Register Clear
’1’
’1’
11
1111 1111
Protect Flag is also
cleared (cleared
Flag = 1)
PREN
Protect Register Enable
’1’
’1’
00
11XX XXXX
PRDS
Protect Register Disable
’1’
’1’
00
0000 0000
OTPbit is set
permanently
Note:
1. X = don’t care bit.
Table 6. InstructionSet
6/16
ST93CS66, ST93CS67
相關PDF資料 |
PDF描述 |
|---|---|
| ST93CS67 | 4K (256 x 16) Serial Microwire EEPROM(4K位串行EEPROM) |
| STA016 | MPEG 2.5 LAYER III AUDIO DECODER SUPPORTING CD-ROM CAPABILITY |
| STA016A | MPEG 2.5 LAYER III AUDIO DECODER SUPPORTING CD-ROM CAPABILITY |
| STA304A | 20 POS IMAGE SENSOR SOCKT |
| STA400A | XMRADIO SDARS CHANNEL DECODER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ST93CS66B1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microwire Serial EEPROM |
| ST93CS66B1013TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4K 256 x 16 SERIAL MICROWIRE EEPROM |
| ST93CS66B3 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microwire Serial EEPROM |
| ST93CS66B3013TR | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:4K 256 x 16 SERIAL MICROWIRE EEPROM |
| ST93CS66B6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microwire Serial EEPROM |
發布緊急采購，3分鐘左右您將得到回復。