參數資料
型號： ST7FL05Y0MBTRE
廠商： STMICROELECTRONICS
元件分類： 微控制器/微處理器
英文描述： 8-BIT, FLASH, 16 MHz, MICROCONTROLLER, PDSO16
封裝： 0.150 INCH, ROHS COMPLIANT, PLASTIC, SOP-16
文件頁數： 49/104頁
文件大?。?/td> 2151K
代理商： ST7FL05Y0MBTRE
Obsolete
Product(s)
- Obsolete
Product(s)
ST7L05, ST7L09
49/104
12-BIT AUTORELOAD TIMER (Cont’d)
Figure 30. PWM Signal Example
Output Compare Mode
To use this function, the OE bit must be 0, other-
wise the compare is done with the shadow register
instead of the DCRx register. Software must then
write a 12-bit value in the DCR0H and DCR0L reg-
isters. This value is loaded immediately (without
waiting for an OVF event).
The DCR0H must be written first, the output com-
pare function starts only when the DCR0L value is
written.
When the 12-bit upcounter (CNTR) reaches the
value stored in the DCR0H and DCR0L registers,
the CMPF0 bit in the PWM0CSR register is set
and an interrupt request is generated if the CMPIE
bit is set.
Note: The output compare function is only availa-
ble for DCRx values other than 0 (reset value).
Caution: At each OVF event, the DCRx value is
written in a shadow register, even if the DCR0L
value has not yet been written (in this case, the
shadow register will contain the new DCR0H value
and the old DCR0L value), then:
– If OE = 1 (PWM mode): The compare is done be-
tween the timer counter and the shadow register
(and not DCRx).
– if OE = 0 (OCMP mode): The compare is done
between the timer counter and DCRx. There is
no PWM signal.
The compare between DCRx or the shadow regis-
ter and the timer counter is locked until DCR0L is
written.
11.2.4 Low Power Modes
11.2.5 Interrupts
Notes:
1. The interrupt events are connected to separate inter-
rupt vectors (see Interrupts chapter).
They generate an interrupt if the enable bit is set in the
ATCSR register and the interrupt mask in the CC register
is reset (RIM instruction).
2. Only if CK0 = 1 and CK1 = 0.
COUNTER
PW
M0
OUTPU
T
t
WI
TH
OE
0
=
1
AN
D
OP0
=
0
FFDh
FFEh
FFFh
FFDh
FFEh
FFFh
FFDh
FFEh
DCR0 = FFEh
ATR = FFDh
fCOUNTER
Mode
Description
SLOW
The input frequency is divided by 32
WAIT
No effect on AT timer
ACTIVE HALT
AT timer halted except if CK0 = 1,
CK1 = 0 and OVFIE = 1
HALT
AT timer halted
Interrupt
Event1)
Event
Flag
Enable
Control
Bit
Exit
from
Wait
Exit
from
Halt
Exit
from
Active
Halt
Overflow
Event
OVF
OVFIE
Yes
No
Yes2)
CMP Event
CMPFx CMPIE
Yes
No
1
相關PDF資料
PDF描述
ST7FL05Y0MATRE 8-BIT, FLASH, 16 MHz, MICROCONTROLLER, PDSO16
ST7FLCD1G9M1 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PDSO28
ST7FLIT19BF1U6TR 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, QCC20
ST7FLITE09Y0M1 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDSO16
ST7FLU05MAE 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PDSO8
相關代理商/技術參數
參數描述
ST7FL05YMAE 制造商:STMicroelectronics 功能描述:MCU 8BIT ST7 CISC 1.5KB FLASH 3.3V/5V 16SOIC - Rail/Tube
ST7FL09Y0MA 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-bit MCU for automotive with single voltage Flash memory, data EEPROM, ADC, timers, SPI
ST7FL09Y0MAE 功能描述:8位微控制器 -MCU 8-bit MCU Automotive RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
ST7FL09Y0MB 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-bit MCU for automotive with single voltage Flash memory, data EEPROM, ADC, timers, SPI
ST7FL09Y0MBE 制造商:STMicroelectronics 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*