參數資料
型號: ST6253BB6
廠商: 意法半導體
英文描述: 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, EEPROM AND SPI
中文描述: 8位檢察官辦公室/存儲器與阿微控制器/ D轉換器,自動重加載定時器,EEPROM和的SPI
文件頁數: 11/75頁
文件大小: 540K
代理商: ST6253BB6
11/75
ST62T53B/T60B/T63B ST62E60B
MEMORY MAP
(Cont’d)
1.3.6
Data
(DRBR)
Address: E8h
RAM/EEPROM
Bank
Register
Write only
Bit 7-5 = These bits are not used
Bit 4 -
DRBR4
. This bit, when set, selects RAM
Page 2.
Bit 3-2 - Reserved. These bits are not used.
Bit 1 -
DRBR1
. This bit, when set, selects
EEPROM Page 1.
Bit 0 -
DRBR0
. This bit, when set, selects
EEPROM Page 0.
The selection of the bank ismade by programming
the Data RAM Bank Switch register (DRBR regis-
ter) located at address E8h of the Data Space ac-
cording to Table 1. No more than one bank should
be set at a time.
The DRBR register can be addressed like a RAM
Data Space at the address E8h; nevertheless it is
a write only register that cannot be accessed with
single-bit operations. This register is used to select
the desired 64-byte RAM/EEPROM bank of the
Data Space. The number of banks has to be load-
ed in the DRBR register and the instruction has to
point to the selected location as if it was in bank 0
(from 00h address to 3Fh address).
This register is not cleared during the MCU initiali-
zation, therefore it must be written before the first
access to the Data Space bank region. Refer to
the Data Space description for additional informa-
tion. The DRBR register is not modified when an
interrupt or a subroutine occurs.
Notes
:
Care is required when handling the DRBR register
as it is write only. For this reason, it is not allowed
to change the DRBR contents while executing in-
terrupt service routine, as the service routine can-
not save and then restore its previous content. If it
is impossible to avoid the writing of this register in
interrupt service routine, an image of this register
must be saved in a RAM location, and each time
the program writes to DRBR it must write also to
the image register. The image register must be
written first, so if an interrupt occurs between the
two instructions the DRBR is not affected.
In DRBR Register, only 1 bit must be set. Other-
wise two or more pages are enabled in parallel,
producing errors.
Table 3. Data RAM Bank Register Set-up
7
0
-
-
-
DRBR
4
-
-
DRBR
1
DRBR
0
DRBR
ST62T53B
ST62T60B/E60B
ST62T63B
00
None
None
None
01
Not Available
EEPROM Page 0
EEPROM Page 0
02
Not Available
EEPROM Page 1
Not Available
08
Not Available
Not Available
Not Available
10h
RAM Page 2
RAM Page 2
RAM Page 2
other
Reserved
Reserved
Reserved
11
相關PDF資料
PDF描述
ST6253BM3 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, EEPROM AND SPI
ST6253BM1 DIODE ZENER SINGLE 200mW 13Vz 5mA-Izt 0.022 0.1uA-Ir 10 SOD-323 3K/REEL
ST6263BM1 DIODE ZENER SINGLE 200mW 15Vz 5mA-Izt 0.0218 0.1uA-Ir 11 SOD-323 3K/REEL
ST6253CB1 8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, SAFE RESET, AUTO-RELOAD TIMER, EEPROM AND SPI
ST6265BM3 Replaced by PT78HT205 : 5Vout 2A Wide Input Positive Step-Down ISR 3-SIP MODULE -40 to 85
相關代理商/技術參數
參數描述
ST6253BB6/XXX 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
ST6253BM1 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, EEPROM AND SPI
ST6253BM1/XXX 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
ST6253BM3 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:8-BIT OTP/EPROM MCUs WITH A/D CONVERTER, AUTO-RELOAD TIMER, EEPROM AND SPI
ST6253BM3/XXX 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller