- 您現在的位置：買賣IC網 > PDF目錄98142 > SST89V58RD-33-I-PIE 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 PDF資料下載
參數資料
| 型號： | SST89V58RD-33-I-PIE |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 |
| 封裝： | ROHS COMPLIANT, PLASTIC, MS-011AC, DIP-40 |
| 文件頁數： | 38/81頁 |
| 文件大小： | 935K |
| 代理商： | SST89V58RD-33-I-PIE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁當前第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
Data Sheet
FlashFlex51 MCU
SST89E52RD2/RD / SST89E54RD2/RD / SST89E58RD2/RD
SST89V52RD2/RD / SST89V54RD2/RD / SST89V58RD2/RD
43
2006 Silicon Storage Technology, Inc.
S71255-05-000
5/06
The user could use the possible addresses above to select
slave 3 only. Another combination could be to select slave 2
and 3 only as shown below.
More than one slave may have the same SADDR address
as well, and a given address could be used to modify the
address so that it is unique.
6.1.2.2 Using the Broadcast Address to Select Slaves
Using the broadcast address, the master can communicate
with all the slaves at once. It is formed by performing a logi-
cal OR of SADDR and SADEN with ‘0’s in the result treated
as “don’t cares”.
“Don’t cares” allow for a wider range in defining the broad-
cast address, but in most cases, the broadcast address will
be FFH.
On reset, SADDR and SADEN are “0”. This produces an
given address of all “don’t cares” as well as a broadcast
address of all “don’t cares.” This effectively disables Auto-
matic Addressing mode and allows the microcontroller to
function as a standard 8051, which does not make use of
this feature.
6.2 Serial Peripheral Interface
6.2.1 SPI Features
Master or slave operation
10 MHz bit frequency (max)
LSB first or MSB first data transfer
Four programmable bit rates
End of transmission (SPIF)
Write collision flag protection (WCOL)
Wake up from idle mode (slave mode only)
6.2.2 SPI Description
The serial peripheral interface (SPI) allows high-speed syn-
chronous data transfer between the SST89E/V5xRDx and
peripheral devices or between several SST89E/V5xRDx
devices.
Figure 6-4 shows the correspondence between master
and slave SPI devices. The SCK pin is the clock output and
input for the master and slave modes, respectively. The SPI
clock generator will start following a write to the master
devices SPI data register. The written data is then shifted
out of the MOSI pin on the master device into the MOSI pin
of the slave device. Following a complete transmission of
one byte of data, the SPI clock generator is stopped and
the SPIF flag is set. An SPI interrupt request will be gener-
ated if the SPI Interrupt Enable bit (SPIE) and the Serial
Port Interrupt Enable bit (ES) are both set.
An external master drives the Slave Select input pin, SS#/
P1[4], low to select the SPI module as a slave. If SS#/P1[4]
has not been driven low, then the slave SPI unit is not
active and the MOSI/P1[5] port can also be used as an
input port pin.
CPHA and CPOL control the phase and polarity of the SPI
tions of these two bits.
FIGURE
6-4: SPI Master-slave Interconnection
Select Slave 3 Only
Slave 2
Given Address
Possible Addresses
1111 X0X1
1111 1011
1111 1001
Select Slaves 2 and 3 Only
Slaves 2 and 3
Possible Addresses
1111 0011
Slave 1
1111 0001 =
SADDR
+1111 1010 =
SADEN
1111 1X11 =
Broadcast
1255 F19.0
8-bit Shift Register
MSB Master LSB
SPI
Clock Generator
MISO MISO
MOSI MOSI
SCK
SS#
8-bit Shift Register
MSB Slave LSB
VSS
VDD
相關PDF資料 |
PDF描述 |
|---|---|
| SST89V54RD-33-I-PIE | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 |
| SST89E54RC-33-C-PIE | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 |
| SST89E54RC-33-C-NJE | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PQCC44 |
| SST89E52RC-33-C-NJE | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PQCC44 |
| SST89E52RC-33-C-PIE | 8-BIT, FLASH, 33 MHz, MICROCONTROLLER, PDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SST89V58RDA | 制造商:SST 制造商全稱:Silicon Storage Technology, Inc 功能描述:FlashFlex MCU |
| SST8H-D | 功能描述:電纜束帶 Cable Tie 2-Piece 27.5"L (699mm) Lt RoHS:否 制造商:Phoenix Contact 產品:Cable Tie Mounts 類型:Adhesive 顏色:Black 材料:Acrylonitrile Butadiene Styrene (ABS) 長度:19 mm 寬度:19 mm 抗拉強度: |
| SST8H-D0 | 功能描述:電纜束帶 Cable Tie, 2-Piece, 27.5"L (699mm), Ligh RoHS:否 制造商:Phoenix Contact 產品:Cable Tie Mounts 類型:Adhesive 顏色:Black 材料:Acrylonitrile Butadiene Styrene (ABS) 長度:19 mm 寬度:19 mm 抗拉強度: |
| SST8H-D30 | 功能描述:電纜束帶 Cable Tie, 2-Piece, 27.5"L (699mm), Ligh RoHS:否 制造商:Phoenix Contact 產品:Cable Tie Mounts 類型:Adhesive 顏色:Black 材料:Acrylonitrile Butadiene Styrene (ABS) 長度:19 mm 寬度:19 mm 抗拉強度: |
| SST8H-L | 功能描述:電纜束帶 Cable Tie 2-Piece 27.5"L (699mm) Lt RoHS:否 制造商:Phoenix Contact 產品:Cable Tie Mounts 類型:Adhesive 顏色:Black 材料:Acrylonitrile Butadiene Styrene (ABS) 長度:19 mm 寬度:19 mm 抗拉強度: |
發布緊急采購，3分鐘左右您將得到回復。