- 您現在的位置：買賣IC網 > PDF目錄385847 > SLA 24C32 (SIEMENS AG) 32 Kbit (4096 ×8 bit) Serial CMOS-EEPROM with IIC Synchronous 2-Wire Bus(32K位(4096 ×8 位)串行CMOS-EEPROM(帶有IIC同步2線控制)) PDF資料下載
參數資料
| 型號： | SLA 24C32 |
| 廠商： | SIEMENS AG |
| 元件分類： | DRAM |
| 英文描述： | 32 Kbit (4096 ×8 bit) Serial CMOS-EEPROM with IIC Synchronous 2-Wire Bus(32K位(4096 ×8 位)串行CMOS-EEPROM(帶有IIC同步2線控制)) |
| 中文描述： | 32千位（4096 × 8位）串行的CMOS EEPROM，帶有國際進口同步2線巴士（32K的位（4096 × 8位）串行的CMOS EEPROM的（帶有國際進口同步2線控制）） |
| 文件頁數： | 10/28頁 |
| 文件大?。?/td> | 368K |
| 代理商： | SLA 24C32 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
SLx 24C32
Semiconductor Group
10
1999-02-02
The conventions for the serial clock line and the bidirectional data line are shown in
figure 4
.
Figure 4
I
2
C-Bus Timing Conventions
for START Condition, STOP Condition, Data
Validation and Transfer of Acknowledge ACK
Standby
Mode in which the bus is not busy (no serial transmission, no
programming): both clock (SCL) and data line (SDA) are in high
state. The device enters the standby mode after a STOP condition
or after a programming cycle.
High to low transition of SDA when SCL is high, preceding all
commands.
Low to high transition of SDA when SCL is high, terminating all
communications. A STOP condition after writing data initiates an
EEPROM programming cycle. A STOP condition after reading
data from the EEPROM initiates the standby mode.
A successful reception of eight data bits is indicated by the
receiver by pulling down the SDA line during the following clock
cycle of SCL (ACK). The transmitter on the other hand has to
release the SDA line after the transmission of eight data bits.
The EEPROM as the receiving device responds with an
acknowledge, when addressed. The master, on the other side,
acknowledges each data byte transmitted by the EEPROM and
can at any time end a read operation by releasing the SDA line (no
ACK) followed by a STOP condition.
Data must change only during low SCL state, data remains valid
on the SDA bus during high SCL state. Nine clock pulses are
required to transfer one data byte, the most significant bit (MSB)
is transmitted first.
START Condition
STOP Condition
Acknowledge
Data Transfer
1
2
8
9
1
9
ACK
ACK
START Condition
Data allowed
to Change
STOP Condition
Acknowledge
SCL
SDA
IED02128
相關PDF資料 |
PDF描述 |
|---|---|
| SLE 24C32 | 32 Kbit (4096 ×8 bit) Serial CMOS-EEPROM with IIC Synchronous 2-Wire Bus(32K位(4096 ×8 位)串行CMOS-EEPROM(帶有IIC同步2線控制)) |
| SLA 24C64 | 64 Kbit (8192 ×8 bit) Serial CMOS-EEPROM with IIC Synchronous 2-Wire Bus(64K位 (8192 ×8 位)串行CMOS-EEPROM(帶有IIC同步2線控制)) |
| SLE 24C64 | 64 Kbit (8192 ×8 bit) Serial CMOS-EEPROM with IIC Synchronous 2-Wire Bus(64K位 (8192 ×8 位)串行CMOS-EEPROM(帶有IIC同步2線控制)) |
| SLA24C164-D | 16 Kbit 2048 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus |
| SLE24C164-D | 16 Kbit 2048 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SLA24C32-D | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:32 Kbit 4096 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus |
| SLA24C32-D/P | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:32 Kbit 4096 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus |
| SLA24C32-D-3 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:32 Kbit 4096 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus |
| SLA24C32-D-3/P | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:32 Kbit 4096 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus |
| SLA24C32-S | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:32 Kbit 4096 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus |
發布緊急采購，3分鐘左右您將得到回復。