- 您現在的位置：買賣IC網 > PDF目錄98081 > SL15100ZIT-XXX (SILICON LABORATORIES) 200 MHz, OTHER CLOCK GENERATOR, PDSO8 PDF資料下載
參數資料
| 型號： | SL15100ZIT-XXX |
| 廠商： | SILICON LABORATORIES |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 200 MHz, OTHER CLOCK GENERATOR, PDSO8 |
| 封裝： | 0.173 INCH, ROHS COMPLIANT, TSSOP-8 |
| 文件頁數： | 5/16頁 |
| 文件大?。?/td> | 379K |
| 代理商： | SL15100ZIT-XXX |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
Rev 1.8, August 10, 2007
Page 13 of 16
SL15100
External Components & Design Considerations
Typical Application Schematic
Comments and Recommendations
Decoupling Capacitor:
A decoupling capacitor of 0.1μF must be used between VDD and VSS on the pins 1 and 5.
Place the capacitor on the component side of the PCB as close to the VDD pin as possible. The PCB trace to the
VDD pin and to the GND via should be kept as short as possible Do not use vias between the decoupling capacitor
and the VDD pin.
Series Termination Resistor
: A series termination resistor is recommended if the distance between the output
(SSCLK) and the load is over 1 inch. The nominal impedance of the SSCLK output is about 30 . Use 20
resistor in series with the output to terminate 50 trace impedance and place 20 resistor as close to the SSCLK
output as possible.
Crystal and Crystal Load:
Use only parallel resonant fundamental crystals. DO NOT USE higher overtone crystals.
To meet the crystal initial accuracy specification (in ppm); the internal on-chip programmable capacitors PCin and
PCout must be programmed to match the crystal load requirement. These values are given by the formula below:
PCin(pF) =PCout(pF)= [(CL(pF) – Cp(pF)/2)] x 2
Where CL is crystal load capacitor as given by the crystal datasheet and Cp(pF) is the compensation factor for the
total parasitic capacitance at XIN or XOUT pin including PCB related parasitic capacitance.
As an example; if a crystal with CL=18pF is used and Cp=4pF, by using the above formula, PCin=PCout=[(18-(4/2)] x
2 = 32pF. Programming PCin and PCout to 32pF assures that this crystal sees an equivalent load of 18pF and no
other external crystal load capacitor is needed. Deviating from the crystal load specification could cause an increase
in frequency accuracy in ppm. Refer to the Table 5 for the recommended crystal specifications.
相關PDF資料 |
PDF描述 |
|---|---|
| SL15100ZCT-XXX | 200 MHz, OTHER CLOCK GENERATOR, PDSO8 |
| SL15102DI-XXX | OTHER CLOCK GENERATOR, DSO8 |
| SL15300EZCT-XXX | 200 MHz, OTHER CLOCK GENERATOR, PDSO8 |
| SL15300EZI-XXX | 200 MHz, OTHER CLOCK GENERATOR, PDSO8 |
| SL15300EZIT-XXX | 200 MHz, OTHER CLOCK GENERATOR, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SL15100ZI-XXX | 制造商:SPECTRALINEAR 制造商全稱:SPECTRALINEAR 功能描述:Prigrammable Spread Spectrum Clock Generator (SSCG) |
| SL15101 | 制造商:SPECTRALINEAR 制造商全稱:SPECTRALINEAR 功能描述:Programmable Spread Spectrum Clock Generator (SSCG) |
| SL15101ZCT-XXX | 制造商:SPECTRALINEAR 制造商全稱:SPECTRALINEAR 功能描述:Programmable Spread Spectrum Clock Generator (SSCG) |
| SL15101ZC-XXX | 制造商:SPECTRALINEAR 制造商全稱:SPECTRALINEAR 功能描述:Programmable Spread Spectrum Clock Generator (SSCG) |
| SL15101ZIT-XXX | 制造商:SPECTRALINEAR 制造商全稱:SPECTRALINEAR 功能描述:Programmable Spread Spectrum Clock Generator (SSCG) |
發布緊急采購，3分鐘左右您將得到回復。