- 您現在的位置：買賣IC網 > PDF目錄2016 > SI2493-D-GT (Silicon Laboratories Inc)IC ISOMODEN GLOBAL DAA 24TSSOP PDF資料下載
參數資料
| 型號： | SI2493-D-GT |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 37/60頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ISOMODEN GLOBAL DAA 24TSSOP |
| 標準包裝： | 62 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
Si2493
42
Rev. 1.3
5. S-Registers
The S command allows reading (Sn?) or writing (Sn = x) the S-registers. The S-registers store values for functions
that typically are rarely changed, such as timers or counters, and the ASCII values of control characters, such as
carriage return. Table 13 summarizes the S-register set.
Table 13. S-Register Description
Definition
S-Register
(Decimal)
Function
Default
(Decimal)
Range
Units
0
Automatic answer—Number of rings the Si2493 must
detect before answering a call. 0 disables auto answer.
0
0–255
Rings
1
Ring counter.
0
0–255
Rings
2
ESC code character.
43 (+)
0–255
ASCII
3
Carriage return character.
13 (CR)
0–255
ASCII
4
Linefeed character.
10 (LF)
0–255
ASCII
5
Backspace character.
08 (BS)
0–255
ASCII
6
Dial tone wait timer—Number of seconds the Si2493
waits before blind dialing. Only applicable if blind dial-
ing is enabled (X0, X1, X3).
02
0–255
seconds
7
Carrier wait timer—Number of seconds the Si2493
waits for carrier before timing out. This register also
sets the number of seconds the modem waits for ring-
back when originating a call before hanging up. This
register also sets the number of seconds the answer
tone will continue while using the AT
*Y2A command.
80
0–255
seconds
8
Dial pause timer for , and < dial command modifiers.
02
0–255
seconds
9
Carrier presence timer—Time after a loss of carrier
that a carrier must be detected before reactivating
DCD. S9 is referred to as “carrier loss debounce time.”
06
1–255
0.1 second
10
Carrier loss timer—Time the carrier must be lost before
the Si2493 disconnects. Setting 255 disables discon-
nect entirely. If S10 is less than S9, even a momentary
loss of carrier causes a disconnect.
14
1–255
0.1 second
12
Escape code guard timer—Minimum guard time
required before and after “+++” for the Si2493 to rec-
ognize a valid escape sequence.
50
1–255
0.02 second
14
Wait for dial tone delay value (in relation to the W dial
modifier). Starts when “W” is executed in the dial
string.
12
0–255
seconds
相關PDF資料 |
PDF描述 |
|---|---|
| SI2494-A-GM | IC ISOMODEM 56KBPS 38-QFN |
| SI3000-C-GS | IC VOICE CODEC 3.3V/5V 16SOIC |
| SI3011-F-FS | IC VOICE DAA GCI/PCM/SPI 16SOIC |
| SI3012-KS | IC LINE-SIDE DAA 16SOIC |
| SI3019-F-FS | IC LINE-SIDE DAA 16SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI2493-D-GTR | 制造商:Silicon Laboratories Inc 功能描述:56 KBPS, V.92 ISOMODEM SYSTEM-SIDE - LEAD-FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEN GLOBAL DAA 24TSSOP 制造商:Silicon Laboratories Inc 功能描述:56 kbps V92 ISOmodem System-Side PBF |
| Si2493-E-FT | 制造商:SILABS 制造商全稱:SILABS 功能描述:Evaluation Board Rev 5.0 for the Si2493/57/34/15/04 |
| Si2493FS08-EVB | 功能描述:網絡開發工具 16-pin Si2493+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| Si2493FS18-EVB | 功能描述:網絡開發工具 16-pin Si2493+Si3018 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| SI2493-FT | 功能描述:電信線路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。