- 您現在的位置：買賣IC網 > PDF目錄2016 > SI2493-D-GT (Silicon Laboratories Inc)IC ISOMODEN GLOBAL DAA 24TSSOP PDF資料下載
參數資料
| 型號： | SI2493-D-GT |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 15/60頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ISOMODEN GLOBAL DAA 24TSSOP |
| 標準包裝： | 62 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
Si2493
22
Rev. 1.3
4.16. Overcurrent Detection
The Si2493 includes an overcurrent detection feature
that measures the loop current at a programmable time
after the Si2493 goes off-hook. This allows the Si2493
to detect if it is connected to an improper telephone line.
The overcurrent detection feature may be enabled by
setting the OCDM bit (U70, bit 11). OHT (U77, bits 8:0)
sets the delay after off-hook until the loop current is
measured. See “AN93: ISOmodem Chipset Family
Designer's Guide” for details.
4.17. Global Operation
The Si2493 chipset contains an integrated silicon direct
access arrangement (Silicon DAA) that provides a
programmable line interface to meet international
telephone line interface requirements. “AN93: Modem
Designer’s Guide” gives the DAA register settings
required to meet international PTT standards.
Additionally, the user-access registers (via the AT:U and
AT:R commands) may be programmed for country-
specific settings, such as dial tone, ring, ringback, and
busy tone. See AN93 for complete details.
4.18. Firmware Upgrades
The Si2493 contains an on-chip program ROM that
includes the firmware required for the features listed in
this data sheet. In addition, the Si2493 contains on-chip
program RAM to accommodate minor changes to the
ROM firmware. This allows Silicon Labs to provide
future firmware updates to optimize the characteristics
of new modem designs and those already deployed in
the field. See AN93 for complete details.
4.19. DTMF Detection / Generation
The Si2493 provides comprehensive DTMF tone
generation and detection. The ISOmodem can generate
single tones or DTMF tones using the +VTS command.
DTMF tones may also be generated during dialing using
the “ATDT” command. DTMF detection is only available
in voice mode (FCLASS = 8). DTMF digits are reported
from the modem to the host using <DLE> shielding.
4.20. SMS/MMS Support
Short Message Service (SMS) is a service that allows
text messages to be sent and received from one
telephone to another via an SMS service center.
Multimedia Messaging Service (MMS) extends the core
SMS
capability
to
send
messages
that
include
multimedia content. The Fax ISOmodem provides an
interface that offers a great deal of flexibility in handling
multiple SMS standards. This flexibility is possible
because most of the differences between standards are
handled by the host using the raw data itself. The
Si2493
performs
the
necessary
modulation/
demodulation of the data and provides two options for
message packet structure (Protocol 1 and Protocol 2, as
defined in ETSI ES 201 912). The rest of the data link
layer and transfer layer are defined by the host system.
The content of the message is entirely up to the host
including any checksum or CRC. ETSI ES 201 912
describes two standard data and transfer layers that are
commonly
used.
SMS
typically
relies
on
caller
identification information to determine if the call should
be answered using an SMS device or not.
See “6.4. SMS Support” in AN93 for more information
on how to configure the modem for SMS support.
4.21. Codec Interface (24-Pin Version Only)
In order to support a full range of voice and data
applications, the Si2493 includes an optional serial
interface that connects to an external voice codec
(Si3000). See AN93 for complete details.
4.22. EEPROM Interface
(24-Pin Version Only)
The Si2493 supports an optional serial peripheral
interface (SPI) bus serial EEPROM Mode 3 with a 16-bit
(8–64 kbit range) address. Upon powerup, if a pulldown
resistor
10 k is placed between D6 and GND, the
ISOmodem attempts to detect an EEPROM. The
EEPROM is intended first for setting custom defaults,
second for automatically loading firmware upgrades,
and third to allow for user-defined AT command macros
for use in custom AT commands or country codes. See
AN93 for complete details.
4.23. AT Commands
At powerup, the Si2493 is in the AT command mode. In
command mode, the modem monitors the input (serial
or parallel) checking constantly for a valid command (AT
commands are described in Table 8.)
相關PDF資料 |
PDF描述 |
|---|---|
| SI2494-A-GM | IC ISOMODEM 56KBPS 38-QFN |
| SI3000-C-GS | IC VOICE CODEC 3.3V/5V 16SOIC |
| SI3011-F-FS | IC VOICE DAA GCI/PCM/SPI 16SOIC |
| SI3012-KS | IC LINE-SIDE DAA 16SOIC |
| SI3019-F-FS | IC LINE-SIDE DAA 16SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SI2493-D-GTR | 制造商:Silicon Laboratories Inc 功能描述:56 KBPS, V.92 ISOMODEM SYSTEM-SIDE - LEAD-FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEN GLOBAL DAA 24TSSOP 制造商:Silicon Laboratories Inc 功能描述:56 kbps V92 ISOmodem System-Side PBF |
| Si2493-E-FT | 制造商:SILABS 制造商全稱:SILABS 功能描述:Evaluation Board Rev 5.0 for the Si2493/57/34/15/04 |
| Si2493FS08-EVB | 功能描述:網絡開發工具 16-pin Si2493+Si3008 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| Si2493FS18-EVB | 功能描述:網絡開發工具 16-pin Si2493+Si3018 ISOmodem Eval Board RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| SI2493-FT | 功能描述:電信線路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。