參數資料
型號: SCANPSC110FDMQB
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 微控制器/微處理器
英文描述: SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support)
中文描述: SPECIALTY MICROPROCESSOR CIRCUIT, CDIP28
封裝: CERAMIC, DIP-28
文件頁數: 2/29頁
文件大?。?/td> 459K
代理商: SCANPSC110FDMQB
Connection Diagrams
(Continued)
Order Number
SCANPSC110FFMQB
SCANPSC110FDMQB
SCANPSC110FLMQB
Description
Military Flatpak
Military DIP
Military Leadless Chip Carrier
Pin
Names
TCK
B
TMS
B
TDI
B
TDO
B
TRST
S
(0,5)
OE
TCK
L(1–3)
TMS
L(1–3)
TDI
L(1–3)
TDO
L(1–3)
Description
Backplane Test Clock Input
Backplane Test Mode Select Input
Backplane Test Data Input
Backplane Test Data Output
Asynchronous Test Reset Input (Active low)
Address Select Port
Local Scan Port Output Enable (Active low)
Local Port Test Clock Output
Local Port Test Mode Select Output
Local Port Test Data Input
Local Port Test Data Output
Table of Contents
1.
GLOSSARY OF TERMS:
2.
DETAILED PIN DESCRIPTION TABLE:
3.
OVERVIEW OF SCAN BRIDGE FUNCTIONS:
A. SCANPSC110F Bridge Architecture:
B. SCANPSC110F Bridge State Machines:
4.
TESTER/SCANPSC110F BRIDGE INTERFACE:
5.
REGISTER SET:
8
6.
ADDRESSING SCHEME:
7.
HIERARCHICAL TEST SUPPORT:
8.
LEVEL 1 PROTOCOL:
A. Addressing Modes:
B. Direct Addressing:
C. Broadcast Addressing:
D. Multi-Cast Addressing:
9.
LEVEL 2 PROTOCOL:
A. Level 2 Instruction Types:
2
3
4
4
4
8
8
9
9
9
10
10
10
11
11
B. Level 2 Instruction Descriptions:
10.
REGISTER DESCRIPTIONS:
11.
SPECIAL FEATURES:
A. BIST Support:
B. RESET:
16
C. Port Synchronization:
12.
ABSOLUTE MAXIMUM RATINGS:
13.
RECOMMENDED OPERATING CONDITIONS:
14.
DC ELECTRICAL CHARACTERISTICS:
15.
AC ELECTRICAL CHARACTERISTICS:
16.
AC WAVEFORMS:
22
17.
APPENDIX:
24
A. State Diagram for Boundary-Scan TAP Control-
ler:
24
18.
APPLICATIONS EXAMPLE:
12
14
16
16
16
18
18
18
20
24
TABLE 1. Glossary of Terms
LFSR
Linear Feedback Shift Register. When enabled, will generate a 16-bit signature of sampled serial
test data.
Local Scan Port. A four signal port that drives a “l(fā)ocal” (i.e. non-backplane) scan chain. (e.g.,
TCK
L1
, TMS
L1
, TDO
L1
, TDI
L1
)
Local is used to describe IEEE Std. 1149.1 compliant scan rings and the SCANPSC110F Bridge
Test Access Port that drives them. The term “l(fā)ocal” was adopted from the system test architecture
that the ’PSC110F Bridge will most commonly be used in; namely, a system test backplane with a
’PSC110F Bridge on each card driving up to 3 “l(fā)ocal” scan rings per card. (Each card can contain
multiple ’PSC110Fs, with 3 local scan ports per ’PSC110F.)
Park, parked, unpark, and unparked, are used to describe the state of the LSP controller and the
state of the local TAP controllers (the “l(fā)ocal TAP controllers” refers to the TAP controllers of the
scan components that make up a local scan ring). Park is also used to describe the action of
parking a LSP (transitioning into one of the Parked LSP controller states). It is important to
understand that when a LSP controller is in one of the parked states, TMS
L
is held constant,
thereby holding or “parking” the local TAP controllers in a given state.
Test Access Port as defined by IEEE Std. 1149.1
Selected and Unselected refers to the state of the ’PSC110F Bridge Selection Controller. A
selected ’PSC110F has been properly addressed and is ready to receive Level 2 protocol.
Unselected ’PSC110Fs monitor the system test backplane, but do not accept Level 2 protocol
(except for the GOTOWAIT instruction). The data registers and LSPs of unselected ’PSC110Fs are
not accessible from the system test master.
LSP
Local
Park/Unpark
TAP
Selected/Unselected
S
www.national.com
2
相關PDF資料
PDF描述
SCANPSC110FFMQB SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support)
SCANPSC110FLMQB SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support)
SCANSTA101 RES 30K OHM 1/16W 0.1% 0402 SMD
SCANSTA111SM EMITTER IR 850NM 5MM RADIAL
SCANSTA111 Enhanced SCAN bridge Multidrop Addressable IEEE 1149.1 (JTAG) Port
相關代理商/技術參數
參數描述
SCANPSC110FDMQB WAF 制造商:Texas Instruments 功能描述:
SCANPSC110FDMQB WAF 制造商:Texas Instruments 功能描述:
SCANPSC110FFMQB 制造商:NSC 制造商全稱:National Semiconductor 功能描述:SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port (IEEE1149.1 System Test Support)
SCANPSC110FLMQB 功能描述:IC BRIDGE LCC SCAN MUL JTAG PORT RoHS:否 類別:集成電路 (IC) >> 接口 - 專用 系列:* 標準包裝:3,000 系列:- 應用:PDA,便攜式音頻/視頻,智能電話 接口:I²C,2 線串口 電源電壓:1.65 V ~ 3.6 V 封裝/外殼:24-WQFN 裸露焊盤 供應商設備封裝:24-QFN 裸露焊盤(4x4) 包裝:帶卷 (TR) 安裝類型:表面貼裝 產品目錄頁面:1015 (CN2011-ZH PDF) 其它名稱:296-25223-2
SCANPSC110FSC 功能描述:特定功能邏輯 SCAN JTAG Port RoHS:否 制造商:Texas Instruments 產品: 系列:SN74ABTH18502A 工作電源電壓:5 V 封裝 / 箱體:LQFP-64 封裝:Tube