- 您現在的位置：買賣IC網 > PDF目錄11828 > SC16C850IET,151 (NXP Semiconductors)IC UART SINGLE W/FIFO 36-TFBGA PDF資料下載
參數資料
| 型號： | SC16C850IET,151 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 21/55頁 |
| 文件大小： | 0K |
| 描述： | IC UART SINGLE W/FIFO 36-TFBGA |
| 標準包裝： | 490 |
| 特點： | 可編程 |
| 通道數： | 1，UART |
| FIFO's： | 128 字節 |
| 規程： | RS485 |
| 電源電壓： | 2.5 V ~ 3.3 V |
| 帶自動流量控制功能： | 是 |
| 帶IrDA 編碼器/解碼器： | 是 |
| 帶故障啟動位檢測功能： | 是 |
| 帶調制解調器控制功能： | 是 |
| 帶CMOS： | 是 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 36-TFBGA |
| 供應商設備封裝： | 36-TFBGA（3.5x3.5） |
| 包裝： | 托盤 |
| 其它名稱： | 935284685151 SC16C850IET-S SC16C850IET-S-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁
SC16C850
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 2 — 11 November 2010
28 of 55
NXP Semiconductors
SC16C850
2.5 to 3.3 V UART with 128-byte FIFOs and IrDA encoder/decoder
7.6 Modem Control Register (MCR)
This register controls the interface with the modem or a peripheral device.
Table 18.
LCR[1:0] word length
LCR[1]
LCR[0]
Word length (bits)
00
5
01
6
10
7
11
8
Table 19.
Modem Control Register bits description
Bit
Symbol
Description
7
MCR[7]
Clock select
logic 0 = divide-by-1 clock input
logic 1 = divide-by-4 clock input
6
MCR[6]
IR enable (see Figure 22).
logic 0 = enable the standard modem receive and transmit input/output
interface (normal default condition)
logic 1 = enable infrared IrDA receive and transmit inputs/outputs. While
in this mode, the TX/RX output/inputs are routed to the infrared
encoder/decoder. The data input and output levels will conform to the
IrDA infrared interface requirement. As such, while in this mode, the
infrared TX output will be a logic 0 during idle data conditions.
5
MCR[5]
Interrupt type (Intel mode only). In Intel mode (16/68 = 1), this pin
determines the interrupt output pin configuration.
logic 0 = CMOS output
logic 1 = open-source. A 300
Ω to 500 Ω pull-down resistor is required.
In Motorola mode (16/68 = 0), the output is always open-drain.
4
MCR[4]
Loopback. Enable the local loopback mode (diagnostics). In this mode the
transmitter output (TX) and the receiver input (RX), CTS, DSR, CD, and RI
are disconnected from the SC16C850 I/O pins. Internally the modem data
and control pins are connected into a loopback data configuration (see
Figure 9). In this mode, the receiver and transmitter interrupts remain fully
operational. The Modem Control Interrupts are also operational, but the
interrupts’ sources are switched to the lower four bits of the Modem Control.
Interrupts continue to be controlled by the IER register.
logic 0 = disable Loopback mode (normal default condition)
logic 1 = enable local Loopback mode (diagnostics)
3MCR[3]
OP2. This bit is used for internal Loopback mode only. In Loopback mode,
this bit is used to write the state of the modem CD interface signal.
2MCR[2]
OP1. This bit is used for internal Loopback mode only. In Loopback mode,
this bit is used to write the state of the modem RI interface signal.
1MCR[1]
RTS
logic 0 = force RTS output to a logic 1 (normal default condition)
logic 1 = force RTS output to a logic 0
0MCR[0]
DTR
logic 0 = force DTR output to a logic 1 (normal default condition)
logic 1 = force DTR output to a logic 0
相關PDF資料 |
PDF描述 |
|---|---|
| SC16IS750IPW-T | IC UART I2C/SPI 24-TSSOP |
| ATMEGA16L-8MUR | MCU AVR 16KB FLASH 16MHZ 44QFN |
| VE-B5B-IY | CONVERTER MOD DC/DC 95V 50W |
| VE-B3Y-IY | CONVERTER MOD DC/DC 3.3V 33W |
| VE-B3W-IY | CONVERTER MOD DC/DC 5.5V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16C850IET-G | 功能描述:UART 接口集成電路 16C 2.5-5V 5MBPS UART 128BFIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C850IET-S | 功能描述:UART 接口集成電路 16C 2.5-5V 5MBPS UART 128BFIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C850L | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:1.8 V single UART, 5 Mbit/s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 mode or 68 mode parallel bus interface |
| SC16C850LIB,128 | 制造商:NXP Semiconductors 功能描述: |
| SC16C850LIB,151 | 制造商:NXP Semiconductors 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。