參數資料
型號： SC16C550BIBS,151
廠商： NXP Semiconductors
文件頁數： 5/48頁
文件大小： 0K
描述： IC UART SINGLE W/FIFO 32-HVQFN
標準包裝： 490
特點： 可編程
通道數： 1，UART
FIFO's： 16 字節
電源電壓： 2.5V，3.3V，5V
帶自動流量控制功能： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
帶CMOS： 是
安裝類型： 表面貼裝
封裝/外殼： 32-VFQFN 裸露焊盤
供應商設備封裝： 32-HVQFN（5x5）
包裝： 托盤
其它名稱： 568-3263
935279497151
SC16C550BIBS-S
SC16C550B_5
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 1 October 2008
13 of 48
NXP Semiconductors
SC16C550B
5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
6.4 Hardware/software and time-out interrupts
Following a reset, the transmitter interrupt is enabled, the SC16C550B will issue an
interrupt to indicate that the Transmit Holding Register is empty. This interrupt must be
serviced prior to continuing operations. The ISR register provides the current singular
highest priority interrupt only. Only after servicing the higher pending interrupt will the
lower priority be reected in the status register. Servicing the interrupt without
investigating further interrupt conditions can result in data errors.
When two interrupt conditions have the same priority, it is important to service these
interrupts correctly. Receive Data Ready and Receive Time-Out have the same interrupt
priority (when enabled by IER[0]). The receiver issues an interrupt after the number of
characters have reached the programmed trigger level. In this case, the SC16C550B
FIFO may hold more characters than the programmed trigger level. Following the removal
of a data byte, the user should re-check LSR[0] for additional characters. A Receive
Time-Out will not occur if the receive FIFO is empty. The time-out counter is reset at the
center of each stop bit received or each time the Receive Holding Register (RHR) is read.
The actual time-out value is 4 character time, including data information length, start bit,
parity bit, and the size of stop bit, that is, 1
×, 1.5×, or 2× bit times.
(1) RTS is de-asserted when the receiver receives the rst data bit of the sixteenth byte. The receive FIFO is full after nishing the
sixteenth byte.
(2) RTS is asserted again when there is at least one byte of space available and no incoming byte is in processing, or there is more
than one byte of space available.
(3) When the receive FIFO is full, the rst receive buffer register read re-asserts RTS.
Fig 9.
RTS functional timing waveforms, RX FIFO trigger level = 14 bytes
byte 14
byte 15
RX
RTS
IOR
Start
byte 18
Stop
Start
byte 16
Stop
002aaa051
RTS released after the
first data bit of byte 16
相關PDF資料
PDF描述
ATMEGA168-15AZ MCU AVR 16K FLASH 15MHZ 32-TQFP
SC16C550BIBS,128 IC UART SOT617-1
XR17C158CV-F IC UART PCI BUS 5V OCTAL 144LQFP
XR17D158CV-F IC UART PCI BUS OCTAL 144LQFP
ATMEGA168-15MZ MCU AVR 16K FLASH 15MHZ 32-QFN
相關代理商/技術參數
參數描述
SC16C550BIBS-F 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIBS-S 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIN40 制造商:NXP Semiconductors 功能描述:UART 16BYTE FIFO 16C550 DIP40
SC16C550BIN40,112 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550IA44 制造商:NXP Semiconductors 功能描述:UART 16BYTE FIFO 16C550 PLCC44
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*