參數資料
型號: SAK-XC2285M-56F80LAA
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: RISC MICROCONTROLLER, PQFP144
封裝: 0.50 mm pitch, GREEN, PLASTIC, LQFP-144
文件頁數: 140/142頁
文件大小: 1112K
代理商: SAK-XC2285M-56F80LAA
XC2287M, XC2286M, XC2285M
XC2000 Family Derivatives / Base Line
Electrical Parameters
Data Sheet
97
V2.0, 2009-03
Active Mode Power Supply Current
The actual power supply current in active mode not only depends on the system
frequency but also on the configuration of the XC228xM’s subsystem.
Besides the power consumed by the device logic (Table 16) the power supply pins also
provide the current that flows through the pin output drivers.
A small current is consumed because the drivers’ input stages are switched.
The IO power domains can be supplied separately. Power domain A (
V
DDPA) supplies the
A/D converters and Port 6. Power domain B (
V
DDPB) supplies the on-chip EVVRs and all
other ports.
During operation domain A draws a maximum current of 1.5 mA for each active A/D
converter module from
V
DDPA.
In Fast Startup Mode (with the Flash modules deactivated), the typical current is reduced
to 3 + 0.6
×f
SYS mA.
Table 16
Switching Power Consumption XC228xM
Parameter
Sym-
bol
Values
Unit Note /
Test Condition
Min. Typ.
Max.
Power supply current
(active) with all peripherals
active and EVVRs on
I
SACT
10 +
0.6
×f
SYS
10 +
1.0
×f
SYS
mA
Active mode1)2)3)
f
SYS in [MHz]
1)The pad supply voltage pins (VDDPB) provide the input current for the on-chip EVVRs
and the current consumed by the pin output drivers. A small current is consumed
because the drivers’ input stages are switched.
In Fast Startup Mode (with the Flash modules deactivated), the typical current is reduced to 3 + 0.6
×f
SYS.
2) Please consider the additional conditions described in section “Active Mode Power Supply Current”.
3) The pad supply voltage has only a minor influence on this parameter.
Power supply current
in stopover mode,
EVVRs on
I
SSO
0.7
2.0
mA
Stopover Mode3)
Power supply current
in standby mode
I
SSB
100
250
μA
Standby mode4),
upper voltage area
4) These values are valid if the voltage validation circuits for
V
DDPB (SWD) and VDDIM (PVC_M) are off. Leaving
SWD and PVC_M active adds another 90
μA.
Power supply current
in standby mode
I
SSB
–70
150
μA
Standby mode,
lower voltage area
相關PDF資料
PDF描述
SAF-XC2287M-72F80LAA RISC MICROCONTROLLER, PQFP144
SAF-XC2285M-72F80LAA RISC MICROCONTROLLER, PQFP144
SAK-XC2723X-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAH-XC2723X-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAK-XC2765X-72F80LAA 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
SAK-XC2286-56F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAK-XC2286-72F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAK-XC2286-96F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAKXC2286M104F80LAA 制造商:Infineon Technologies AG 功能描述:
SAK-XC2287-56F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance