參數(shù)資料
型號: SAK-XC2285M-56F80LAA
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: RISC MICROCONTROLLER, PQFP144
封裝: 0.50 mm pitch, GREEN, PLASTIC, LQFP-144
文件頁數(shù): 122/142頁
文件大?。?/td> 1112K
代理商: SAK-XC2285M-56F80LAA
XC2287M, XC2286M, XC2285M
XC2000 Family Derivatives / Base Line
Functional Description
Data Sheet
80
V2.0, 2009-03
3.16
Watchdog Timer
The Watchdog Timer is one of the fail-safe mechanisms which have been implemented
to prevent the controller from malfunctioning for longer periods of time.
The Watchdog Timer is always enabled after an application reset of the chip. It can be
disabled and enabled at any time by executing the instructions DISWDT and ENWDT
respectively. The software has to service the Watchdog Timer before it overflows. If this
is not the case because of a hardware or software failure, the Watchdog Timer
overflows, generating a prewarning interrupt and then a reset request.
The Watchdog Timer is a 16-bit timer clocked with the system clock divided by 16,384
or 256. The Watchdog Timer register is set to a prespecified reload value (stored in
WDTREL) in order to allow further variation of the monitored time interval. Each time it
is serviced by the application software, the Watchdog Timer is reloaded and the
prescaler is cleared.
Time intervals between 3.2
μs and 13.4 s can be monitored (@ 80 MHz).
The default Watchdog Timer interval after power-up is 6.5 ms (@ 10 MHz).
3.17
Clock Generation
The Clock Generation Unit can generate the system clock signal
f
SYS for the XC228xM
from a number of external or internal clock sources:
External clock signals with pad voltage or core voltage levels
External crystal or resonator using the on-chip oscillator
On-chip clock source for operation without crystal/resonator
Wake-up clock (ultra-low-power) to further reduce power consumption
The programmable on-chip PLL with multiple prescalers generates a clock signal for
maximum system performance from standard crystals, a clock input signal, or from the
on-chip clock source. See also Section 4.6.2.
The Oscillator Watchdog (OWD) generates an interrupt if the crystal oscillator frequency
falls below a certain limit or stops completely. In this case, the system can be supplied
with an emergency clock to enable operation even after an external clock failure.
All available clock signals can be output on one of two selectable pins.
相關PDF資料
PDF描述
SAF-XC2287M-72F80LAA RISC MICROCONTROLLER, PQFP144
SAF-XC2285M-72F80LAA RISC MICROCONTROLLER, PQFP144
SAK-XC2723X-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAH-XC2723X-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAK-XC2765X-72F80LAA 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP100
相關代理商/技術參數(shù)
參數(shù)描述
SAK-XC2286-56F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAK-XC2286-72F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAK-XC2286-96F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAKXC2286M104F80LAA 制造商:Infineon Technologies AG 功能描述:
SAK-XC2287-56F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance