- 您現在的位置：買賣IC網 > PDF目錄98075 > SAF-XE162FM-48F80L (INFINEON TECHNOLOGIES AG) 16-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | SAF-XE162FM-48F80L |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP64 |
| 封裝： | 0.50 MM PITCH, GREEN, PLASTIC, LQFP-64 |
| 文件頁數： | 65/107頁 |
| 文件大?。?/td> | 1608K |
| 代理商： | SAF-XE162FM-48F80L |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁當前第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁
XE162FM, XE162HM
XE166 Family / Base Line
Electrical Parameters
Data Sheet
60
V2.1, 2011-07
Absolute sum of overload
currents
Σ|I
OV|
SR
50
mA
not subject to
production test
Digital core supply voltage
for domain M
8)
V
DDIM
CC
1.5
Digital core supply voltage
for domain 1
V
DDI1
CC
1.5
Digital supply voltage for
IO pads and voltage
regulators
V
DDP SR
4.5
5.5
V
Digital ground voltage
V
SS SR
0
V
1) To ensure the stability of the voltage regulators the EVRs must be buffered with ceramic capacitors. Separate
buffer capacitors with the recomended values shall be connected as close as possible to each
V
DDIM and VDDI1
pin to keep the resistance of the board tracks below 2 Ohm. Connect all
V
DDI1 pins together. The minimum
capacitance value is required for proper operation under all conditions (e.g. temperature). Higher values
slightly increase the startup time.
2) Use one Capacitor for each pin.
3) This is the reference load. For bigger capacitive loads, use the derating factors listed in the PAD properties
section.
4) The timing is valid for pin drivers operating in default current mode (selected after reset). Reducing the output
current may lead to increased delays or reduced driving capability (
C
L).
5) The operating frequency range may be reduced for specific device types. This is indicated in the device
designation (...FxxL). 80 MHz devices are marked ...F80L.
6) Overload conditions occur if the standard operating conditions are exceeded, i.e. the voltage on any pin
exceeds the specified range:
V
OV > VIHmax (IOV > 0) or VOV < VILmin ((IOV < 0). The absolute sum of input
overload currents on all pins may not exceed 50 mA. The supply voltages must remain within the specified
limits. Proper operation under overload conditions depends on the application. Overload conditions must not
occur on pin XTAL1 (powered by
V
DDIM).
7) An overload current (
I
OV) through a pin injects a certain error current (IINJ) into the adjacent pins. This error
current adds to the respective pins leakage current (
I
OZ). The amount of error current depends on the overload
current and is defined by the overload coupling factor
K
OV. The polarity of the injected error current is inverse
compared to the polarity of the overload current that produces it.The total current through a pin is |
I
TOT| = |IOZ|
+ (|
I
OV| KOV). The additional error current may distort the input voltage on analog inputs.
8) Value is controlled by on-chip regulator
Table 12
Operating Conditions (cont’d)
Parameter
Symbol
Values
Unit
Note /
Test Condition
Min.
Typ.
Max.
相關PDF資料 |
PDF描述 |
|---|---|
| SAF-XE162FM-72FXXL | RISC MICROCONTROLLER, PQFP64 |
| SAF-XE162HM-72FXXL | RISC MICROCONTROLLER, PQFP64 |
| SAF-XE167F-96F66L | 16-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQFP144 |
| SAF-XE167G-72F66L | 16-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQFP144 |
| SAF82525NV2.1 | 2 CHANNEL(S), 4M bps, MULTI PROTOCOL CONTROLLER, PQCC44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAF-XE162FM-48F80L AA | 功能描述:16位微控制器 - MCU 16 BIT FLASH C11 IMM RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAF-XE162FM-72F80L AA | 功能描述:16位微控制器 - MCU MICROCONTROLLER 16-BIT RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAF-XE162FM-72F80L AA TR | 制造商:Infineon Technologies AG 功能描述: |
| SAF-XE162FN-16F80L AA | 功能描述:16位微控制器 - MCU 16 BIT FLASH RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
| SAF-XE162FN-24F80L AA | 功能描述:16位微控制器 - MCU 16 BIT FLASH RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。