- 您現在的位置：買賣IC網 > PDF目錄98075 > SAF-XC2786X-96F80L66 (INFINEON TECHNOLOGIES AG) 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 PDF資料下載
參數資料
| 型號： | SAF-XC2786X-96F80L66 |
| 廠商： | INFINEON TECHNOLOGIES AG |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 |
| 封裝： | 0.50 MM PITCH, GREEN, PLASTIC, LQFP-144 |
| 文件頁數： | 101/120頁 |
| 文件大小： | 1434K |
| 代理商： | SAF-XC2786X-96F80L66 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁當前第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁
XC2786X
XC2000 Family Derivatives
Electrical Parameters
Data Sheet
79
V2.1, 2008-08
2) Not subject to production test - verified by design/characterization. Hysteresis is implemented to avoid
metastable states and switching due to internal ground bounce. It cannot suppress switching due to external
system noise under all conditions.
3) The maximum deliverable output current of a port driver depends on the selected output driver mode, see
Table 13, Current Limits for Port Output Drivers. The limit for pin groups must be respected.
4) As a rule, with decreasing output current the output levels approach the respective supply level (
V
OL→VSS,
VOH→VDDP). However, only the levels for nominal output currents are verified.
5) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage is determined by the external circuit.
6) An additional error current (
I
INJ) will flow if an overload current flows through an adjacent pin. Please refer to
the definition of the overload coupling factor
KOV.
The leakage current value is not tested in the lower voltage range but only in the upper voltage range. This
parameter is ensured by correlation.
7) The given values are worst-case values. In production test, this leakage current is only tested at 125°C; other
values are ensured by correlation. For derating, please refer to the following descriptions:
Leakage derating depending on temperature (
T
J = junction temperature [°C]):
IOZ = 0.03 × e(1.35 + 0.028×TJ) [A]. For example, at a temperature of 130°C the resulting leakage current is
4.41
A.
Leakage derating depending on voltage level (DV =
VDDP - VPIN [V]):
I
OZ = IOZtempmax - (1.3 × DV) [A]
This voltage derating formula is an approximation which applies for maximum temperature.
Because pin P2.8 is connected to two pads (standard pad and high-speed clock pad), it has twice the normal
leakage.
8) Keep current: Limit the current through this pin to the indicated value so that the enabled pull device can keep
the default pin level:
V
PIN ≥ VIH for a pullup; VPIN ≤ VIL for a pulldown.
Force current: Drive the indicated minimum current through this pin to change the default pin level driven by
the enabled pull device:
V
PIN ≤ VIL for a pullup; VPIN ≥ VIH for a pulldown.
These values apply to the fixed pull-devices in dedicated pins and to the user-selectable pull-devices in
general purpose IO pins.
9) Not subject to production test - verified by design/characterization.
Because pin P2.8 is connected to two pads (standard pad and high-speed clock pad), it has twice the normal
capacitance.
相關PDF資料 |
PDF描述 |
|---|---|
| SAF-XC886-6FFA5V | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
| SAK-XC886-6FFA3V3 | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
| SAK-XC886-6FFA5V | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
| SAF-XC888-6FFI3V3 | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP64 |
| SAF-XC886-6FFI5V | 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SAF-XC822-1FRA | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller |
| SAF-XC822-1FRA AA | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| SAF-XC822-1FRI | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller |
| SAF-XC822-1FRI AA | 功能描述:8位微控制器 -MCU 8-Bit Single Chip Microcontroller RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| SAF-XC822-1FRIAA | 制造商:Infineon 功能描述:8-Bit Single-Chip Microcontroller 制造商:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。