參數資料
型號： S1D13600F00A
元件分類： 顯示控制器
英文描述： CRT OR FLAT PNL GRPH DSPL CTLR, PQFP64
封裝： QFP6-64
文件頁數： 28/29頁
文件大?。?/td> 190K
代理商： S1D13600F00A
S1D13600 Series
1–8
EPSON
Rev. 2.3
5. PIN DESCRIPTION
Key
C
= CMOS level input
CS
= CMOS level input with hysteresis
COSC
= CMOS level input for an internal oscillation inverter
T
= TTL level input
OX
= CMOS output, x denotes output driver type.
OOSC
= CMOS output for an internal oscillation inverter
PU
= integrated pull-up resistor
PD
= integrated pull-down resistor
CPU Interface
The CPU interface signals are placed on one side of the chip for easy connection to CPU. And the input
levels of all CPU Interface pins are unified with CMOS level to allow easy connection to 3.3 V 68 family
CPUs.
Table 2. CPU Interface Pin Description
Pin Name
Type Pin No.
Drv
Description
Data inputs. The data is captured into an
D [0:7]
I
2…9
C
S1D13600’s input data register by the rising edge
of “
CS”.
In Active Mode, “E” is used to write or read the
E
I
15
C
CPU data to from SRAM and transfer the data
written in the SRAM to the LCD Module.
The rising edge of this signal is used to capture the
CS
I
14
C
state of “D [0:7] and “DT/
CM” into S1D13600.
When “
CS” is HIGH, no data captures occur.
DT/
CM
I13
C
If this signal is HIGH, Data is on the bus. If this
signal is LOW, Command is on the bus.
If this signal is pulled LOW, the chip enters Sleep
Mode. In the Sleep Mode, internal oscillation is
SLEEP
I
11
C
disabled, all of the input signals are masked and all
of the output signals are controlled to inactive
state.
RESET
I10
CS
The active LOW “
RESET” signal from the system
clears all internal registers.
SRAM Interface
The SRAM Interface signals are basically placed on two sides of the chip. The input level of “VD [0:7]”
is met with TTL level to connect with generic 3.3 V SRAMs. And also “VD [0:7]” have integrated pull-
up resistors to eliminate current consumption at the input buffers in Doze Mode.
相關PDF資料
PDF描述
S1D13700F02A100 320 X 240 PIXELS CRT OR FLAT PNL GRPH DSPL CTLR, PQFP64
S1D13706F00A 320 X 240 PIXELS CRT OR FLAT PNL GRPH DSPL CTLR, PQFP100
S1D13806F00A CRT OR FLAT PNL GRPH DSPL CTLR, PQFP144
S1D13A05B00B 320 X 320 PIXELS CRT OR FLAT PNL GRPH DSPL CTLR, PBGA121
S1D13A05F00A100 320 X 320 PIXELS CRT OR FLAT PNL GRPH DSPL CTLR, PBGA121
相關代理商/技術參數
參數描述
S1D13700 制造商:EPSON 制造商全稱:EPSON 功能描述:Embedded Memory Graphics LCD Controller
S1D13700F01A100 功能描述:顯示驅動器和控制器 LCD CONTROLLER RoHS:否 制造商:Panasonic Electronic Components 工作電源電壓:2.7 V to 5.5 V 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Reel
S1D13700F02A100 功能描述:顯示驅動器和控制器 (QVGA) 320x240 B/W STN LCD C RoHS:否 制造商:Panasonic Electronic Components 工作電源電壓:2.7 V to 5.5 V 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:QFN-44 封裝:Reel
S1D13701F00A100 功能描述:LCD 驅動器 Organic EL Controller RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
S1D13702F00A100 功能描述:LCD 驅動器 Organic EL Controller RoHS:否 制造商:Maxim Integrated 數位數量:4.5 片段數量:30 最大時鐘頻率:19 KHz 工作電源電壓:3 V to 3.6 V 最大工作溫度:+ 85 C 最小工作溫度:- 20 C 封裝 / 箱體:PDIP-40 封裝:Tube
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*