參數資料
型號： S1C88816D
元件分類： 微控制器/微處理器
英文描述： 8-BIT, MROM, 8.2 MHz, MICROCONTROLLER, UUC164
封裝： DIE-164
文件頁數： 117/173頁
文件大小： 1411K
代理商： S1C88816D
40
EPSON
S1C88816 TECHNICAL MANUAL
5 PERIPHERAL CIRCUITS AND THEIR OPERATION (Output Ports)
Since the FOUT signal is generated asynchronously
from the register FOUTON, when the signal is
turned ON or OFF by the register settings, a hazard
of a 1/2 cycle or less is generated.
Figure 5.5.5.4 shows the output waveform of the
FOUT signal.
FOUTON
FOUT output (R34)
01
0
Fig. 5.5.5.4 Output waveform of FOUT signal
s BZ output (R50), BZ output (R51)
In order for the S1C88816 to drive an external
buzzer, the BZ signal (sound generator output) can
be output from the output port terminal R50.
Furthermore, the R51 output port terminal can be
used to output the BZ signal (BZ inverted signal).
The configuration of the output ports R50 and R51
is shown in Figure 5.5.5.5.
BZ signal
R
SQ
One-shot
time up
R50 output
Register BZSTP
Register BZON
Register BZSHT
Register R50D
R51 output
Mask option
Register R51D
Fig. 5.5.5.5 Configuration of R50 and R51
The output control for the BZ (BZ) signal is done by
the registers BZON, BZSHT and BZSTP. When you
set "1" for the BZON or BZSHT, the BZ (BZ) signal
is output from the output port terminal R50 (R51).
When "0" is set for the BZON or "1" is set for the
BZSTP, the R50 goes LOW (VSS) and the R51 goes
HIGH (VDD).
To output the BZ signal, "0" must always be set for
the data register R50D. The data register R51D does
not affect the BZ output.
The BZ (BZ) signal is generated by the sound
generator. With respect to control of frequency and
envelope, see "5.12 Sound Generator".
Since the BZ (BZ) signal is generated asynchro-
nously from the registers BZON, BZSHT and
BZSTP, when the signal is turned ON or OFF by
setting the registers, a hazard of a 1/2 cycle or less
is generated.
Figure 5.5.5.6 shows the output waveform of the BZ
(BZ) signal.
BZON/BZSHT
BZ output (R50)
BZ output (R51) *
00
1
when selected by mask option
Fig. 5.5.5.6 BZ (BZ) output waveform
s MOUT and MOUT outputs
MOUT and MOUT are the output ports dedicated
to direct driving an external piezoelectric buzzer
with the melody signal. These ports are fixed at
complementary output and cannot be set into high-
impedance state. Also data register is not available.
At initial reset, the MOUT and MOUT terminals go
HIGH.
See "5.13 Melody Generator" for melody output.
相關PDF資料
PDF描述
S1C88832F0A0100 MICROCONTROLLER, PQFP128
S1C88848D0A0100 8-BIT, MROM, 8.2 MHz, MICROCONTROLLER, UUC192
S1C8F360F 8-BIT, FLASH, 8.2 MHz, MICROCONTROLLER, PQFP176
S1D13305F00B 640 X 256 PIXELS CRT CHAR OR GRPH DSPL CTLR, PQFP60
S1D13305F00A 640 X 256 PIXELS CRT CHAR OR GRPH DSPL CTLR, PQFP60
相關代理商/技術參數
參數描述
S1C88848 制造商:EPSON 制造商全稱:EPSON 功能描述:8-bit Single Chip Microcomputer
S1C8F360D411000 功能描述:16位微控制器 - MCU 8-bit Flash 60KB LCD Dr. 51 x 32 RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
S1C8F360D511000 功能描述:16位微控制器 - MCU 8-bit Flash 60KB LCD Dr. 51 x 32 RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
S1C8F360F413100 功能描述:16位微控制器 - MCU 8-bit Flash 60KB LCD Dr. 51 x 32 RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
S1C8F360F513200 功能描述:16位微控制器 - MCU 8-bit Flash 60KB LCD Dr. 51 x 32 RoHS:否 制造商:Texas Instruments 核心:RISC 處理器系列:MSP430FR572x 數據總線寬度:16 bit 最大時鐘頻率:24 MHz 程序存儲器大小:8 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:VQFN-40 安裝風格:SMD/SMT
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*