- 您現在的位置：買賣IC網 > PDF目錄382430 > RF5C296 (RICOH COMPANY LTD) TRI N PLUG F PLAS 4-20 PDF資料下載
參數資料
| 型號： | RF5C296 |
| 廠商： | RICOH COMPANY LTD |
| 元件分類： | 總線控制器 |
| 英文描述： | TRI N PLUG F PLAS 4-20 |
| 中文描述： | PCMCIA BUS CONTROLLER, PQFP144 |
| 封裝： | 1.70 MM HEIGHT, PLASTIC, LQFP-144 |
| 文件頁數： | 29/93頁 |
| 文件大?。?/td> | 449K |
| 代理商： | RF5C296 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁
RF5C296/RF5C396L/RB5C396/RF5C396
25
Setting the bit0 of the Mode Control Register 1 (Index=1Fh) to “1” configures the corresponding card slot to the
PCMCIA-ATA mode. In PCMCIA-ATA mode, if the bit1 of the Mode Control Register is set to “1”, the SPKR# input
works as an LED input and IRQ12 works as an open drain LED output. At this time SPKROUT# will become inac-
tive.
Bits2 to 6 can be set to specify the values of the CA21 to CA25 pin signals (marked with “
*
” in the pin definition
table in the PCMCIA-ATA Mode on the previous page). In the PCMCIA-ATA Mode, the output CA21 to CA25 pin
signals assume the values thus specified by bits2 to 6.
Bit7 can be set to prevent any conflict between the system floppy disk signal and the card interface signals.
When set to “1”, bit7 is disabled during reading from an I/O address of 3F7h and 377h on the system data bus.
Mode Control Register 1 (Index=1Fh)
bit7
377h, 3F7h Disable
(in I/O Read)
bit6
A25
bit5
A24
bit4
A23
bit3
A22
bit2
A21
bit1
LED Enable
bit0
PCMCIA-
ATA Mode
RF5C296/RF5C396 provide the DMA Mode for supporting interfacing with external floppy disk units or other
DMA devices via the PC card slots. Setting bit1 of Mode Control Register 3 to “1” enables DMA mode. The DMA
data will be transferred to/from DMA capable PC Card with the ISA bus as a DMA master.
On the DMA mode, some of RF5C296/RF5C396 signal pins will be redefined. IRQ9 will work as DACK# input,
IRQ10 will work as DREQ output, IRQ11 (or IRQ15) will work as TC input.
DREQ from the PC Card can be assigned to one of three PCMCIA inputs (IOIS16#, SPKR# or INPACK#) by set-
ting bit7 and bit6 of Mode Control Register 2.
DMA transfer between the ISA system memory and the I/O card is available in the following two types :
1) DMA transfer between the ISA system memory and the I/O card
2) DMA transfer between memory in the I/O card and the I/O port via the system data bus.
Notice
ISA bus
DREQ
DACK#
TC
IRQ 10
IRQ 9
IRQ 11(or15)
IOIS 16#
SPKR#
or INPACK#
DREQ
DACK#
IOIS 16# ,
SPKR#,
or INPACK#
REG#
PC card
RF5C296/FR5C396
DMA made configuration
REG#
Only one slot at a time should be enabled for DMA transfer. And DMA transfer to/from DMA capable PC Card
may be 8 or 16bit as shown in the bus sizing table of page 21.
9. DMA Mode
相關PDF資料 |
PDF描述 |
|---|---|
| RF5C396 | TRI N PLUG F PLAS 12-19 |
| RF5C396L | TRI N PLUG F PLAS 0-48 |
| RF5C62 | REAL-TIME CLOCK |
| RG2A2 | 1300V，Damper Diodes(For Display)(1300V，阻尼二極管(用于顯示器）) |
| RG2Y | 70V，Ultra-Fast-Recovery Rectifier Diodes(70V，超快恢復整流二極管) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RF5C396 | 制造商:RICOH 制造商全稱:RICOH electronics devices division 功能描述:PC Card Controller compliant with PCMCIA 2.1/JEIDA 4.2 |
| RF5C396L | 制造商:RICOH 制造商全稱:RICOH electronics devices division 功能描述:PC Card Controller compliant with PCMCIA 2.1/JEIDA 4.2 |
| RF5C59 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:UART |
| RF5C62 | 制造商:RICOH 制造商全稱:RICOH electronics devices division 功能描述:REAL-TIME CLOCK |
| RF5C67 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
發布緊急采購，3分鐘左右您將得到回復。