- 您現在的位置：買賣IC網 > PDF目錄374585 > RF2905 (RF MICRO DEVICES INC) 433/868/915MHZ FM/FSK/ASK/OOK TRANSCEIVER PDF資料下載
參數資料
| 型號： | RF2905 |
| 廠商： | RF MICRO DEVICES INC |
| 元件分類： | 通信及網絡 |
| 英文描述： | 433/868/915MHZ FM/FSK/ASK/OOK TRANSCEIVER |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PQFP48 |
| 封裝： | 7 X 7 MM, PLASTIC, LQFP-48 |
| 文件頁數： | 6/22頁 |
| 文件大?。?/td> | 490K |
| 代理商： | RF2905 |
11-58
RF2905
Rev B11 010516
11
T
Pin
13
Function
IF1 IN+
Description
Balanced IF input to the 40dB limiting amplifier strip. A 10nF DC block-
ing capacitor is required on this input.
Interface Schematic
14
IF1 IN-
Functionally the same as pin 13 except inverting node amplifier input.
In single-ended applications, this input should be bypassed directly to
ground through a 10nF capacitor.
DC feedback node for the 40dB limiting amplifier strip. A 10nF bypass
capacitor from this pin to ground is required.
Same as pin 15.
See pin 13.
15
IF1 BP+
See pin 13.
16
IF1 BP-
See pin 13.
17
IF1 OUT
IF output from the 40dB limiting amplifier. The IF1 OUT output presents
a nominal 330
output resistance and interfaces directly to 10.7MHz
ceramic filters.
18
IF2 IN
Balanced IF input to the 60dB limiting amplifier strip. A 10nF DC block-
ing capacitor is required on this input. The IF2 IN input presents a nom-
inal 330
input resistance and interfaces directly to 10.7MHz ceramic
filters.
19
GND6
Ground connection for 60dB IF limiting amplifier. Keep traces physically
short and connect immediately to ground plane for best performance.
DC voltage reference for the IF limiting amplifiers. A 10nF capacitor
from this pin to ground is required.
DC feedback node for the 60dB limiting amplifier strip. A 10nF bypass
capacitor from this pin to ground is required.
Same as pin 21.
20
VREF IF
21
IF2 BP+
See pin 18.
22
23
IF2 BP-
MUTE
See pin 18.
This pin is used to mute the data output (DATA OUT). MUTE>2.0V
turns the DATA OUT signal on. MUTE<1.0V turns the DATA OUT sig-
nal off. The MUTE signal should be logic low in the Sleep Mode.
24
RSSI
A DC voltage proportional to the received signal strength is output from
this pin. The output voltage range is 0.5V to 2.5V, into 51k
load, and
increases with increasing signal strength.
25
FM OUT
Linear output from the FM demodulator. This pin is used in analog
applications when signal fidelity is important. This output is inverted for
low side injection of the LO and normal for high side injection.
26
DATA OUT
Demodulated data output from the demodulator. Output levels on this
are TTL/CMOS compatible. The magnitude of the load impedance is
intended to be 1M
or greater. When using a RF2905 transmitter and
receiver back to back a data inversion will occur, when the LO is low
side injected. A high side injection will add an inversion of the Rx data.
IF1 IN-
IF1 IN+
330
330
60 k
60 k
IF1 BP+
IF1 BP-
IF1 OUT
IF2 IN
330
330
60 k
60 k
IF2 BP+
IF2 BP-
25 k
75 k
MUTE
V
CC
RSSI
FM OUT
DATA OUT
相關PDF資料 |
PDF描述 |
|---|---|
| RF2908 | 915MHZ SPREAD SPECTRUM RECEIVER WITH PLL FREQUENCY SYNTHESIZER |
| RF340 | 10A, 400V, 0.550 Ohm, N-Channel Power MOSFET |
| RF3808S | Power MOSFET(Vdss=75V, Rds(on)=0.007ohm, Id=106A) |
| RF3S49092SM | 20A/10A, 12V, 0.060/0.140 Ohm, Logic Level, Complementary Power MOSFET |
| RF3V49092 | 20A/10A, 12V, 0.060/0.140 Ohm, Logic Level, Complementary Power MOSFET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RF2905-000 | 制造商:TE Connectivity 功能描述:Gas Discharge Tubes 200VDC 1KADC 0.5pF Solder Pad SMD 制造商:TE Connectivity 功能描述:GDT - Tape and Reel |
| RF2906-000 | 制造商:TE Connectivity 功能描述:GDT - Tape and Reel 制造商:TE Connectivity 功能描述:GAS TUBE 6MM 90V 20% 5KA AXIAL |
| RF2907-000 | 制造商:TE Connectivity 功能描述:GDT - Trays |
| RF2908 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:915MHZ SPREAD SPECTRUM RECEIVER WITH PLL FREQUENCY SYNTHESIZER |
| RF2909 | 制造商:RFMD 制造商全稱:RF Micro Devices 功能描述:3V 915MHZ SPREAD-SPECTRUM TRANSMITTER IC |
發布緊急采購，3分鐘左右您將得到回復。