
5-64
RF2658
Rev A8 010720
5
M
U
Pin
11
Function
VCC3
Description
Supply voltage for the AGC and the Bandgap circuitry. A 1nF external
bypass capacitor is required and an additional 0.1
μ
F will be required if
no other low frequency bypass capacitors are nearby. The trace length
between the pin and the bypass capacitors should be minimized. The
ground side of the bypass capacitors should connect immediately to
ground plane. The part is designed to work from 2.7V to 3.3V supply.
Same as pin 6.
Interface Schematic
12
13
GND1
PD1
Power down control for overall circuit. When logic “high” (
≥
V
CC
-0.7V),
all circuits are operating; when logic “l(fā)ow” (
<
0.5V), all circuits are
turned off. The input impedance of this pin is >10k
.
14
VCC4
Supply for the mixer stage only. The supply for the mixer is separated to
maximize IF to RF isolations and reduce the carrier leakage. A 100pF
external bypass capacitor is required and an additional 0.1
μ
F will be
required if no other low frequency bypass capacitors are near by. The
trace length between the pin and the bypass capacitors should be min-
imized. The ground side of the bypass capacitors should connect
immediately to ground plane. The part is designed to work from 2.7V to
3.3V supply.
Power down control for mixer only. When connected to pin 10 (BG
OUT) the mixer circuits are operating; when connected to ground
(
≤
0.5V), the mixer is turned off but all other circuits are operating.
15
PD2
16
GND2
Ground connection for the mixer stage. Keep traces physically short
and connect immediately to ground plane for best performance.
RF output pin. An external shunt inductor to V
CC
plus a series blocking/
matching capacitor are required for 50
output.
17
RF OUT
18
DEC
Current mirror decoupling pin. A 1000pF external capacitor is required
to bypass this pin. The ground side of the bypass capacitors should
connect immediately to ground plane.
One half of the balanced mixer LO2 input. In single-ended applications,
the other half of the input, LO2- is AC grounded. This is a 50
imped-
ance port. This pin is NOT internally DC blocked. An external blocking
capacitor (100pF recommended) must be provided if the pin is con-
nected to a device with DC present.
19
LO2+
20
LO2-
One half of the balance mixer LO2 input. In single ended applications,
this pin is AC grounded with a 100pF capacitor.
One half of the 200
balanced impedance input to the mixer stage.
This pin is NOT internally DC blocked. An external blocking capacitor
(2200pF recommended) must be provided if the pin is connected to a
device with DC present. If no IF filter is needed, this pin may be con-
nected to MOD OUT+ through a DC blocking capacitor. An appropriate
matching network may be needed if an IF filter is used.
See pin 19.
21
MIX IN-
22
MIX IN+
Same as pin 21, except complementary input.
See pin 21.
10 k
PD1
1 k
PD2
450
300
V
CC4
RF OUT
40
BIAS
40
BIAS
LO2+
LO2-
100
BIAS
100
BIAS
MIX IN-
MIX IN+