- 您現在的位置：買賣IC網 > PDF目錄384884 > RF2658 (RF MICRO DEVICES INC) TRANSMIT MODULATOR, IF AGC, AND UPCONVERTER PDF資料下載
參數資料
| 型號： | RF2658 |
| 廠商： | RF MICRO DEVICES INC |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | TRANSMIT MODULATOR, IF AGC, AND UPCONVERTER |
| 中文描述： | TELECOM, CELLULAR, RF AND BASEBAND CIRCUIT, PDSO28 |
| 封裝： | QSOP-28 |
| 文件頁數： | 3/10頁 |
| 文件大?。?/td> | 114K |
| 代理商： | RF2658 |
5-63
RF2658
Rev A8 010720
5
M
U
Pin
1
Function
MODE
Description
Selects between CDMA and FM mode. This is a digitally controlled
input. A logic “high” (
≥
V
CC
-0.7V
DC
) selects CDMA mode. A logic “l(fā)ow”
(
≥
0.5V
DC
) selects FM mode. In FM mode, this switch enables the FM
amplifier and turns off the I&Q modulator. The impedance on this pin is
30k
.
Interface Schematic
2
Q SIG
Baseband input to the Q mixer. This pin is DC coupled. The DC level of
0.6V must be supplied to this pin to bias the transistor. Input imped-
ance of this pin is 50k
minimum.
3
Q REF
Reference voltage for the Q mixer. This voltage should be the same as
the DC voltage supplied to the Q SIG pin. For maximum carrier sup-
pression, DC voltage on this pin relative to the Q SIG DC voltage may
be adjusted. Input impedance of this pin is 50k
minimum.
Reference voltage for the I mixer. This voltage should be the same as
the DC voltage supplied to the I SIG pin. For maximum carrier suppres-
sion, DC voltage on this pin relative to the I SIG DC voltage may be
adjusted. Input impedance of this pin is 50k
minimum.
Baseband input to the I mixer. This pin is DC coupled. The DC level of
0.6V must be supplied to this pin to bias the transistor. Input imped-
ance of this pin is 50k
minimum.
See pin 2.
4
I REF
See pin 5.
5
I SIG
6
GND1
Ground connection for all baseband circuits including bandgap, AGC,
flip-flop, modulator and FM amp. Keep traces physically short and con-
nect immediately to ground plane for best performance.
Supply voltage for the LO1 flip-flop and limiting amp only. This supply is
isolated to minimize the carrier leakage. A 1nF external bypass capaci-
tor is required, and an additional 0.1
μ
F will be required if no other low
frequency bypass capacitors are nearby. The trace length between the
pin and the bypass capacitors should be minimized. The ground side of
the bypass capacitors should connect immediately to ground plane.
The part is designed to work from 2.7V to 3.3V supply.
One half of the balanced modulator LO1 input. The other half of the
input, LO1-, is AC grounded for single-ended input applications. The
frequency on these pins is divided by a factor of 2, hence the carrier
frequency for the modulator becomes one half of the applied frequency.
The single-ended input impedance is 100
(balanced is 200
). This
pin is NOT internally DC blocked. An external blocking capacitor (1nF
recommended) must be provided if the pin is connected to a device
with DC present. When FM mode is selected, the output of the flip-flop
divider circuit is switched to the AGC amplifier inputs and the modulator
mixers are not used. Note that the frequency deviation input here will
be reduced by a factor of two, due to the frequency divider operation.
One half of the balanced modulator LO1 input. In single-ended applica-
tions (100
input impedance), this pin is AC grounded with a 1nF
capacitor.
Bandgap voltage reference. This voltage, constant over temperature
and supply variation, is used to bias internal circuits. A 1nF external
bypass capacitor is required.
7
VCC1
8
LO1+, FM+
9
LO1-, FM-
See pin 8.
10
BG OUT
60 k
60 k
BIAS
MODE
8 k
8 k
Q SIG
Q REF
BIAS
BIAS
8 k
8 k
I SIG
I REF
BIAS
BIAS
100
100
LO1+, FM+
LO1-, FM-
V
CC1
V
CC1
相關PDF資料 |
PDF描述 |
|---|---|
| RF2667 | RECEIVE AGC AND DEMODULATOR |
| RF2668 | CDMA/FM TRANSMIT MODULATOR, IF AGC, AND UPCONVERTER WITH INTEGRATED PLL |
| RF2670 | 8MHZ DUAL BASEBAND AGC WITH PROGRAMMABLE LOW PASS FILTERING |
| RF2681 | W-CDMA LINEAR VARIABLE GAIN DRIVER AMPLIFIER |
| RF2689 | W-CDMA/GSM/DCS RECEIVE AGC AND DEMODULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| RF2658-000 | 制造商:TE Connectivity 功能描述:RXEF005-2 - Tape and Reel |
| RF2659-000 | 制造商:TE Connectivity 功能描述:- Ammo Pack |
| RF2660-000 | 制造商:TE Connectivity 功能描述:- Ammo Pack |
| RF2661-000 | 制造商:TE Connectivity 功能描述:RESET,60V,40A,0.65A IHLD,1.3A ITRP,RADIAL,AMM,HAZMAT - Ammo Pack |
| RF2662-000 | 制造商:TE Connectivity 功能描述:RXEF017-AP - Ammo Pack |
發布緊急采購，3分鐘左右您將得到回復。