參數資料
型號： PXA255
廠商： Intel Corp.
英文描述： PXA255 Processor
中文描述： PXA255處理器
文件頁數： 18/40頁
文件大?。?/td> 1191K
代理商： PXA255
Package Information
18
Intel PXA255 Processor
Electrical, Mechanical, and Thermal Specification
Table 4. Pin Description Notes
Note
Description
[1]
GPIO reset operation: Configured as GPIO inputs by default after any reset. The input buffers for these pins are
disabled to prevent current drain and the pins are pulled high with 10K to 60K internal resistors. The input paths
must be enabled and the pullups turned off by clearing the read-disable-hold (RDH) bit described in
Section 3.5.7, “Power Manager Sleep Status Register (PSSR)” on page 3-27 in the
Intel PXA255 Processor
Developers Manual
. Even though sleep mode sets the RDH bit, the pull-up resistors are not re-enabled by sleep
mode.
[2]
Crystal oscillator pins:
These pins connect the external crystals to the on-chip oscillators. Refer to Section 3.3.1,
“32.768 kHz Oscillator” on page 3-4 in the
Intel PXA255 Processor Developers Manual
and Section 3.3.2,
“3.6864 MHz Oscillator” on page 3-4 of the
Intel PXA255 Processor Developers Manual
for details on sleep-
mode operation.
[3]
GPIO sleep operation:
The state of these pins is determined by the corresponding PGSRn during the transition
into sleep mode. See Section 3.5.9, “Power Manager GPIO Sleep State Registers (PGSR0, PGSR1, PGSR2)”
and Section 4.1.3.2, “GPIO Pin Direction Registers (GPDR0, GPDR1, GPDR2)” on page 4-8 in the
Intel
PXA255 Processor Developers Manual
. If selected as an input, this pin does not drive during sleep. If selected
as an output, the value contained in the sleep-state register is driven out onto the pin and held there while the
PXA255 processor is in sleep mode.
GPIOs configured as inputs after exiting sleep mode cannot be used until PSSR[RDH] is cleared.
[4]
Static memory control pins: During sleep mode, these pins can be programmed to either drive the value in the
sleep-state register or be placed in Hi-Z. To select the Hi-Z state, software must set the FS bit in the power-
manager general-configuration register. If PCFR[FS] is not set, then during the transition to sleep these pins
function as described in [3], above. For nWE, nOE, and nCS[0], if PCFR[FS] is not set, they are driven high by
the memory controller before entering sleep. If PCFR[FS] is set, these pins are placed in Hi-Z.
[5]
PCMCIA control pins: During sleep mode: can be programmed either to drive the value in the sleep-state
register or be placed in Hi-Z. To select the Hi-Z state, software must set PCFR[FP]. If it is not set, then during the
transition to sleep these pins function as described in [3], above.
[6]
During sleep, this supply may be driven low. This supply must never be high impedance.
[7]
Remains powered in sleep mode.
相關PDF資料
PDF描述
PXA270 Electrical, Mechanical, and Thermal Specification
PXAC37 XA 16-bit microcontroller family 32K/1024 OTP CAN transport layer controller 1 UART, 1 SPI Port, CAN 2.0B, 32 CAN ID Filters, transport layer co-proce
PXB16050U NPN microwave power transistor
PY08-02 INDUSTRIERELAIS FASSUNG PCB
PY08-02186697 SOCKET PCB
相關代理商/技術參數
參數描述
PXA25VC22RMH70TP 制造商:United Chemi-Con Inc 功能描述:Cap Aluminum 22uF 25V 20% (8 X 6.7mm) SMD 0.05 Ohm 1800mA 2000 hr 105°C T/R
PXA270 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:Electrical, Mechanical, and Thermal Specification
PXA300 制造商:Marvell 功能描述:
PXA310 制造商:MARVELL 制造商全稱:MARVELL 功能描述:Rich Multimedia with Scalable Performance up to 624 MHz for Cost-Effective and Power-Effi cient Secure 3.5G Smartphones
PXA320 制造商:MARVELL 制造商全稱:MARVELL 功能描述:Cost-Effective, Scalable Performance up to 806 MHz for Power-Efficient, High-End Multimedia Handsets, Embedded Solutions, and Enterprise-Class Devices
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*