- 您現在的位置：買賣IC網 > PDF目錄98056 > PMN5118USR (ERICSSON POWER MODULES AB) 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | PMN5118USR |
| 廠商： | ERICSSON POWER MODULES AB |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT, SMD-14 |
| 文件頁數： | 23/37頁 |
| 文件大?。?/td> | 1906K |
| 代理商： | PMN5118USR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
Ericsson Internal
PRODUCT SPECIFICATION
3 (4)
Prepared (also subject responsible if other)
No.
EWEIXIE
1/1301-BMR656 5118 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Julia You)
EMINTAO
2007-07-30
B
Safety Specification
General information
Ericsson Power Modules DC/DC converters and DC/DC
regulators are designed in accordance with safety
standards IEC/EN/UL60950,
Safety of Information
Technology Equipment.
IEC/EN/UL60950 contains requirements to prevent injury
or damage due to the following hazards:
Electrical shock
Energy hazards
Fire
Mechanical and heat hazards
Radiation hazards
Chemical hazards
On-board DC-DC converters and DC/DC regulators are
defined as component power supplies. As components
they cannot fully comply with the provisions of any Safety
requirements without “Conditions of Acceptability”.
Clearance between conductors and between conductive
parts of the component power supply and conductors on
the board in the final product must meet the applicable
Safety requirements. Certain conditions of acceptability
apply for component power supplies with limited stand-off
(see Mechanical Information for further information). It is
the responsibility of the installer to ensure that the final
product housing these components complies with the
requirements of all applicable Safety standards and
Directives for the final product.
Component power supplies for general use should comply
with the requirements in IEC60950, EN60950 and
UL60950
“Safety of information technology equipment”.
There are other more product related standards, e.g.
IEEE802.3af “Ethernet LAN/MAN Data terminal equipment
power”, and ETS300132-2 “Power supply interface at the
input to telecommunications equipment; part 2: DC”, but
all of these standards are based on IEC/EN/UL60950 with
regards to safety.
Ericsson Power Modules DC/DC converters and DC/DC
regulators are UL60950 recognized and certified in
accordance with EN60950.
The flammability rating for all construction parts of the
products meets requirements for V-0 class material
according to IEC 60695-11-10.
The products should be installed in the end-use
equipment, in accordance with the requirements of the
ultimate application. Normally the output of the DC/DC
converter is considered as SELV (Safety Extra Low
Voltage) and the input source must be isolated by
minimum Double or Reinforced Insulation from the primary
circuit (AC mains) in accordance with IEC/EN/UL60950.
Isolated DC/DC converters
It is recommended that a slow blow fuse with a rating
twice the maximum input current per selected product be
used at the input of each DC/DC converter. If an input filter
is used in the circuit the fuse should be placed in front of
the input filter.
In the rare event of a component problem in the input filter
or in the DC/DC converter that imposes a short circuit on
the input source, this fuse will provide the following
functions:
Isolate the faulty DC/DC converter from the input
power source so as not to affect the operation of
other parts of the system.
Protect the distribution wiring from excessive
current and power loss thus preventing
hazardous overheating.
The galvanic isolation is verified in an electric strength test.
The test voltage (Viso) between input and output is
1500 Vdc or 2250 Vdc for 60 seconds (refer to product
specification).
Leakage current is less than 1 A at nominal input voltage.
24 V DC systems
The input voltage to the DC/DC converter is SELV (Safety
Extra Low Voltage) and the output remains SELV under
normal and abnormal operating conditions.
48 and 60 V DC systems
If the input voltage to the DC/DC converter is 75 Vdc or
less, then the output remains SELV (Safety Extra Low
Voltage) under normal and abnormal operating conditions.
Single fault testing in the input power supply circuit should
be performed with the DC/DC converter connected to
demonstrate that the input voltage does not exceed
75 Vdc.
If the input power source circuit is a DC power system, the
source may be treated as a TNV2 circuit and testing has
demonstrated compliance with SELV limits and isolation
requirements equivalent to Basic Insulation in accordance
with IEC/EN/UL60950.
Non-isolated DC/DC regulators
The input voltage to the DC/DC regulator is SELV (Safety
Extra Low Voltage) and the output remains SELV under
normal and abnormal operating conditions.
E
PMN 5000 series
POL regulator, Input 4.5-5.5 V, Output up to 30 A/108 W
EN/LZT 146 386 R1A
July 2007
Ericsson Power Modules AB
Technical Specification
3
相關PDF資料 |
PDF描述 |
|---|---|
| PMN8118UWP | 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE |
| PMN8118UWS | 1-OUTPUT 108 W DC-DC REG PWR SUPPLY MODULE |
| PMP5818UWSR | 1-OUTPUT 88 W DC-DC REG PWR SUPPLY MODULE |
| PQ1CF2 | 1.5 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5 |
| PQ1CF2J0000H | 1.5 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P-MN5218 | 制造商:Panasonic Industrial Company 功能描述:IC |
| PMN52XPX | 功能描述:MOSFET P-CH 20V SC-74 制造商:nexperia usa inc. 系列:- 包裝:剪切帶（CT） 零件狀態:在售 FET 類型:P 溝道 技術:MOSFET（金屬氧化物） 漏源電壓（Vdss）:20V 電流 - 連續漏極（Id）（25°C 時）:3.7A（Ta） 驅動電壓（最大 Rds On，最小 Rds On）:1.5V，4.5V 不同 Id 時的 Vgs（th）（最大值）:900mV @ 250μA 不同 Vgs 時的柵極電荷?（Qg）（最大值）:12nC @ 4.5V Vgs（最大值）:±12V 不同 Vds 時的輸入電容（Ciss）（最大值）:763pF @ 10V FET 功能:- 功率耗散（最大值）:530mW（Ta）, 4.46W（Tc） 不同?Id，Vgs 時的?Rds On（最大值）:62 毫歐 @ 3.7A，4.5V 工作溫度:-55°C ~ 150°C（TJ） 安裝類型:表面貼裝 供應商器件封裝:6-TSOP 封裝/外殼:SC-74，SOT-457 標準包裝:1 |
| PMN55LN | 制造商:NXP Semiconductors 功能描述:MOSFET N CH 20V 4.1A SOT457 制造商:NXP Semiconductors 功能描述:MOSFET, N CH, 20V, 4.1A, SOT457 制造商:NXP Semiconductors 功能描述:MOSFET, N CH, 20V, 4.1A, SOT457; Transistor Polarity:N Channel; Continuous Drain Current Id:4.1A; Drain Source Voltage Vds:20V; On Resistance Rds(on):0.055ohm; Rds(on) Test Voltage Vgs:10V; Power Dissipation Pd:1.75W; No. of Pins:6 ;RoHS Compliant: Yes |
| PMN55LN /T3 | 功能描述:MOSFET TAPE13 PWR-MOS RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS（導通）:0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube |
| PMN55LN,135 | 功能描述:MOSFET TAPE13 PWR-MOS RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS（導通）:0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。